Close

Chevrolet S10 Recalls

Get the latest Chevrolet S10 recall updates.

Most Recent Chevrolet S10 Recall

On June 4, 2004, Chevrolet recalled 183,922 Chevrolet S10. Certain pickup trucks and sport utility vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 208, ¿occupant crash protection.¿
Not your car? Find your recalls now:

Chevrolet S10 Recall Details

RepairPal Expert Overview on June 4, 2004

Vehicles may have an air bag warning label with incorrect statements. This is against the Federal Motor Vehicle Safety Standard.

Please contact your GM dealer. They will check to see if your specific vehicle is affected and advise you on what to do next. Always have your vehicle identification number (VIN) handy when you call.

Summary on June 19, 2003
On certain minivans, pickup trucks, and sport utility vehicles with certain model-engine combinations, the windshield wiper motor may fail due to cracked solder joints on the controller circuit board. the windshield wipers could work intermittently or not at all.
RepairPal Expert Overview on October 18, 2000
Vehicle description: light duty pickup trucks and sport utility vehicles. some of these vehicles were built with incorrect payload information on the vehicle certification label. the payload shown on the label is greater than the maximum validated payload. if the vehicle were loaded to the incorrectly labeled payload, it may not ride and handle in the manner that the driver expects.
Summary on September 13, 2000
Vehicle description: light duty pickup trucks and sport utility vehicles. these vehicles fail to comply with the requirements of fmvss no. 108, "lamps, reflective devices, and associated equipment." the daytime running lights built with a candela value greater than 3,000 cannot be mounted higher than 864mm above the road surface.
RepairPal Expert Overview on August 24, 2000
Vehicle description: passenger vehicles, light duty trucks, sport utility vehicles, and mini vans equipped with trw seat belt buckle assemblies. the buckle base of these seat belt assemblies were not properly heat treated and therefore do not pass the load bearing requirement of federal motor vehicle safety standard no. 209, "seat belt assemblies."