What Does P0715 Code Mean?

OBD-II Code P0715 is defined as a Input/Turbine Speed Sensor Circuit Malfunction

The purpose of the automatic transmission is to match the engine's optimum power and torque characteristics to the driver's desired rate of acceleration and speed by auto-selecting different gear ratios or 'speeds' to power the wheels. 

Code P0715 is triggered when the transmission's Input Speed Sensor isn't providing a reliable  or rational signal. This is a critical problem because with out this signal, the Transmission Contorl Module or TCM can't properly shift  the vehicle from gear to gear as the vehicle needs to change speed and rates of acceleration.

P0715 Symptoms

  • Check Engine Light will illuminate
  • Vehicle will not shift properly
  • Decrease in fuel economy
  • In unusual cases, there are no adverse conditions noticed by the driver
  • In some cases, there may be performance problems, such as dying when coming to a stop after driving on the freeway and/or misfire-like symptoms

Common Problems That Trigger the P0715 Code

  • Defective Input/Turbine Speed Sensor
  • Defective Shift Solenoids
  • Defective Engine Coolant Temperature Sensor
  • Defective Valve Body
  • Dirty transmission fluid that restricts the hydraulic passages

Common Misdiagnoses

  • Engine Misfire problem
  • Internal Transmission problem
  • Driveline problem

Polluting Gases Expelled

  • HCs (Hydrocarbons): Unburned droplets of raw fuel that smell, affect breathing, and contribute to smog
  • CO (Carbon Monoxide): Partially burned fuel that is an odorless and deadly poisonous gas
  • NOX (Oxides of Nitrogen): One of the two ingredients that, when exposed to sunlight, cause smog 

P0715 Diagnostic Theory for Shops and Technicians

When the code P0715 is set in the Powertrain Computer, it means that the Powertrain Computer or PCM is not seeing a speed signal from the Input/Turbine Sensor or a greater than a specified RPM difference between the rotational speed of the Input RPM Sensor and the Transmission Output RPM Sensor. This can occur during shifting or when driving at steady speeds in the same gear. It often implies that the transmission is slipping.  Often times the transmission will automatically shift into a default gear and the Check Engine Light will be illuminated.  

When diagnosing a P0715 code, it is important to record the freeze frame information and then to duplicate the code setting conditions with a test drive. Pay close attention to the engine load, throttle position, RPM, and road speed because a P0715 can be difficult to detect. Road test the vehicle while viewing the transmission input and output RPM PID information on a data streaming scanner. If the input RPM speed signal is unreliable or irrational then you may have verified code P0715. Be sure to verify the input speed sensor connection and wiring as well as the flex plate or flywheel teeth. If these all check out normally, then most likely you have a defective Input Speed Signal Sensor. Always use OEM parts and check for any applicable software updates. 


Not the OBD-II Code You're Looking For?

3 User Comments

Sign in to comment
By , May 27, 2017
Where do I find my Input Speed Signal Sensor so I can replace it? Is it hard? My engine light came on, had it hooked up and the P0715 code came up. Want to fix it ourselves. It works better in manual, but terrible in auto. I hate using the manual and I know the longer we wait, the worse it will get. Thanks
By , July 08, 2017
I have a problem I have 2 code PO1624 and PO715 .. I change speed sensor and same problem..!!
By , November 23, 2017
Bought this <a href="">OBD2 Scanner</a>one as I had a check engine light in my car. Very pleased with this code reader and would highly recommend it. Amazing diagnostic device. It helps me a lot and save money.