The total repair cost will vary based on the condition of your vehicle and the number of repairs needed to fix your symptom. Proper diagnosis will save you money by finding the exact repairs needed to fix your car right the first time.
A faulty oxygen sensor is one of the most common causes of a check engine light. Symptoms may include a decrease in fuel mileage, hesitation or misfiring from the engine, rough idling or even stalling. A faulty sensor may cause the vehicle to fail an emissions test.
Any time there is an emissions fault the check engine light will be displayed. The purpose of the check engine light is to inform the driver that an emission related fault has been found, and that there are on-board diagnostic (OBD) trouble codes stored in the powertrain or engine control module. Additionally, since the emissions systems are so intertwined into engine control and transmission control systems, symptoms may include nearly any sort of drivability concerns. This may include harsh shifting, failure to shift, hesitation on acceleration, jerking, engine failure to start or run, loss of power, or any number of other drivability issues.
Due to the nature of electrical systems on modern vehicles, the range of problems these can cause are nearly limitless. However, there is a way to categorize them in two ways. Permanent and intermittent problems. Permanent problems appear and remain. This may be the vehicle will not start, the radio does not work, or the door chime will not turn off among many, many others. These problems are more straight-forward to diagnose since they present themselves at all time. This means there will always be a fault to find. Intermittent electrical problems, however, can be difficult or impossible to locate, since they appear then disappear without warning. The best case scenario for an intermittent issue is when replicating the problem is easily accomplished and understood. This allows a technician to make an issue semi-permanent, allowing them to find the fault. Other issues that come and go without warning and cannot be replicated on demand must occur when the technician is servicing the vehicle, otherwise there is no problem to correct. It is most important to understand that electrical system faults always require inspection, and can include the vehicle working in any manner, or not working at all.
Like we noted in the last section, general diagnosis symptoms are the most vague of the bunch. There are several diagnostic spectrums, electrical diagnosis, drivability diagnostics, engine diagnostics, transmission diagnostics, and the list could continue for about 5 or 10 more spectrums of diagnostics. The most important take-away here, is that general diagnostics are diagnostics that have no other spectrum in which they fit, or the problem is unknown. This means that any vehicle left outside of a repair facility with the keys and an authorization to perform diagnosis will be diagnosed under the general diagnosis spectrum.
When the Check Engine Light comes on, you may experience engine performance issues such as poor acceleration, rough idling, or an engine that won't start. In some cases, no abnormal symptoms will be experienced. Other systems like the transmission or ABS can cause the Check Engine Light to illuminate and lights for those systems can come on at the same time. Similar lights may say "Check Engine Soon", "Malfunction Indicator Light" or just "Check". In rare case the engine can overheat.
When faced with a check engine light on your 2017 Land Rover Discovery Sport, it's essential to adopt a systematic diagnostic approach. Start by checking the gas cap; a loose or damaged cap is a common culprit that can easily trigger the light. Next, take a moment to inspect your dashboard for any additional warning lights or messages that might provide further insight into the problem. Utilizing an OBD-II scanner is a crucial step, as it allows you to retrieve error codes from the vehicle's computer, helping to pinpoint the specific issue at hand. Additionally, visually inspect the engine bay for any signs of damage, such as frayed wires or loose connections, which could indicate underlying problems. Finally, pay attention to your vehicle's performance; any noticeable changes like rough idling or decreased fuel efficiency can offer valuable clues. By following these steps, you can effectively gather information to diagnose and potentially resolve the check engine light issue on your Land Rover.
When the check engine light comes on in a 2017 Land Rover Discovery Sport, it can signal a range of issues that are often manageable for DIY enthusiasts. One of the simplest problems to check is a loose gas cap, which can easily be tightened or replaced if damaged. More complex issues may involve the oxygen sensor, which monitors exhaust gases and can affect fuel efficiency if faulty. If you notice a decrease in performance or unusual sounds, the catalytic converter might be at fault, as it can become clogged or fail over time. Additionally, the mass airflow sensor, responsible for measuring the air entering the engine, can malfunction, leading to poor engine performance. Spark plugs and ignition coils are also critical components; worn or faulty spark plugs can cause misfires, while malfunctioning ignition coils can prevent the engine from firing properly. If you suspect an engine misfire, it’s essential to investigate these components further. While some of these issues can be diagnosed and addressed at home, others may require professional assistance to ensure the vehicle runs smoothly and efficiently. Always remember to consult your vehicle’s manual for specific troubleshooting steps and consider using an OBD-II scanner to read diagnostic trouble codes for more precise identification of the problem.
When the check engine light illuminates in your 2017 Land Rover Discovery Sport, it signals a need for immediate attention, as neglecting this warning can lead to serious consequences. The light may indicate a range of issues, from minor sensor malfunctions to significant engine problems that could compromise your vehicle's performance and safety. Ignoring the check engine light not only risks escalating the problem, potentially resulting in costly repairs, but it can also affect your vehicle's drivability, making it unsafe to operate. For DIY enthusiasts, addressing the check engine light promptly allows for early diagnosis and resolution of the underlying issue, which can save time and money in the long run. By taking action as soon as the light appears, you can ensure your Land Rover remains reliable and safe on the road, preventing minor issues from developing into major repairs.
Read about related problems experienced by other Land Rover Discovery Sport drivers like you.
See what others are asking about their Land Rover Discovery Sport. Get answers from RepairPal's community of auto experts and enthusiasts.