Oldsmobile Alero Problems

Front Windows Come Off Track Due to Broken Sash Brackets on Oldsmobile Alero

Problem Description and Possible Solution

The front window sash brackets may break causing the window to come off track. Our technicians tell us that new brackets are available and can be installed on the old window glass if it is not damaged.

(106 people reported this problem)

Oldsmobile Alero Vehicles With This Problem

RepairPal Verified
Average mileage: 118,528 (10,893–210,000)
6 model years affected: 1999, 2000, 2001, 2002, more2003, 2004
Not Your Oldsmobile Alero Problem?
Brake problem? Or maybe a faulty head gasket cylinder?
Learn About Your Car Problems
Search For a Specific Car Problem
Viewing 1-20 of 52 comments
My mounting tabs on my driver window broke in half! Both of them. Its not expensive to fix if you can do it yourself but it's difficult reaching the front tab.
Bought a new window track online for 20 bucks.It came with the motor, but it was horrible. So I took the plastic white clips off the new and popped them on the old window bracket. Never had to remove anything from the car. Patience Patience Patience
My front driver side window will not go up completely. When it's raining outside, it gets stuck and will not roll up at all
My driver window has come off track plenty and my passenger side window just feel inside the door...I hate the electrics in the car
power window passenger side stopped working took it in to get fixed cost 350.00 2 days later drivers side window fell off track took back in cost 350 again how conveient was that
White plastic kit decided to break when a kid slammed my car door. Took off door panel used JB Weld and reattached clips together, rolled up window, Took the window crank handle off and kept it off. Window permanently stays in up position. It's annoying, as at the time this happened it was over $300 to repair for the parts kit that included a whole bunch of stuff that I didn't need. The solution, the clips cost $1.29 each, but you can't buy them independently you have to buy the kit...
i fixed my passenger window broken brackets by removing the door panel adjusting the window so i could get to the 10 mm bolts holding the broken bracket piece. i then took a piece of flat thin metal and drilled a hole for the 10 mm bolt to go through. i reinstalled the metal piece, bolt and broken back piece(as the broken piece has the threaded insert to hold in place. then i drilled two small holes through the metal piece and the bottom of the part attached to the window and put small machine screws and nuts through them !! holding up fine so far...
Front and back Windows come off of tracks due to broken cable housing at the motor.
Replaced all window regulators. 10/2015