Estimates last updated January 29, 2021

Chevrolet Silverado 1500 Hybrid Inverter Coolant Drain, Flush & Refill Cost

The average cost for a Chevrolet Silverado 1500 Hybrid Inverter Coolant Drain, Flush & Refill is between $110 and $161.

Labor costs are estimated between $110 and $161.
This range does not include taxes and fees, and does not factor in your unique location. Related repairs may also be needed.

Hybrid Inverter Coolant Drain, Flush & Refill

What is a Hybrid Inverter Coolant Drain, Flush & Refill?

Hybrid drive vehicles which use electricity must store that electricity in a direct current (DC) battery. Since the hybrid drive motor uses alternating current (AC), the hybrid inverter must be used to change DC power to AC power. As you may imagine, the high voltage used in the hybrid battery creates a large amount of heat in the inverter as current is changed from DC to AC, so a cooling system must be used. This is much like the cooling system on an engine.

How do Hybrid Inverter Cooling Systems work?

High voltage creates high heat, so the metallic case of the inverter generates lots of heat which must be transferred to a liquid via indirect contact. The cooling system for an inverter may run over, under, around, through, or to the side of the inverter, and the purpose is to absorb the heat byproduct of electricity changing from DC to AC. The coolant passages touch the inverter, the heat moves from the inverter to the cooling passages, and the cool liquid inside the cooling passages absorb that heat and carry it to the radiator. Wind blowing across the radiator cools the liquid in the reverse manner, and the hybrid inverter cooling system pump pushes the cooled liquid back through the cooling passages again.

When does the Hybrid Inverter Cooling System need service?

The inverter will become hot if the hybrid inverter cooling system decreases in efficiency. This may happen if the coolant becomes too old, turns corrosive, or becomes contaminated. When this occurs, the hybrid drive system warning lamp will appear, and the hybrid drive control module will reference the inverter becoming too hot. Also, the hybrid drive system may possibly cease function, and the operation of the vehicle may be suspended as well. However, more often than failure occurs, the system requires a flush, drain, and refill because or system repair or scheduled maintenance.

Chevrolet Hybrid Inverter Coolant Drain, Flush & Refill Cost Estimates

The average cost for a Hybrid Inverter Coolant Drain, Flush & Refill is between $110 and $161 but can vary from car to car.

Chevrolet Silverado 1500

Hybrid Inverter Coolant Drain, Flush & Refill

Jump to:Commonly associated repairs Cost estimates by vehicle

What is a Hybrid Inverter Coolant Drain, Flush & Refill?

How do Hybrid Inverter Cooling Systems work?

When does the Hybrid Inverter Cooling System need service?

Hybrid component failure requires immediate repair. In many cases the vehicle will need to be towed to a repair facility, and servicing the vehicle is not possible without manufacturer specific or hybrid drive training. For vehicles that need the inverter cooling system flushed, drained, and refilled due to scheduled maintenance, this should be done on time or slightly early. It is not wise to have services performed after the service interval has elapsed.

How often should the Hybrid Inverter Cooling System be flushed?

All hybrid vehicles should have the hybrid drive DC to AC inverter cooling system flushed, drained and filled at least once in their useful service life. This is part of the factory scheduled maintenance, and, even if it were not, any service to the inverter or inverter cooling system will require this service to be completed.

How are Hybrid Inverter Cooling Systems diagnosed?

If any of the mentioned symptoms are noted, the cooling system will be checked for leaks, and, if any are found, not only will the leak be repaired, but the system will be flushed and refilled. However, if no leaks are found and the coolant level is correct, the system may be flushed as a diagnostic step. Finally, no diagnosis is normally needed to flush the system because it is a factory scheduled maintenance item. The only symptom necessary is mileage.

How is the Hybrid Inverter Cooling System serviced?

Flushing the hybrid inverter cooling system is much the same as flushing the engine cooling system, except there are fewer components to deal with, and the components are typically more accessible. Chemicals are introduced into the hybrid inverter cooling system through the fill port, and the system is ran. Afterwards, the system is drained, purged of old coolant, and the drain plug is replaced. Finally, the system is filled and purged of air.

RepairPal Recommendations for Hybrid Inverter Cooling System issues

RepairPal always recommends following the factory scheduled maintenance plan when servicing a vehicle. If the service mileage or time has elapsed without the service being performed, have it done next time the vehicle is in for service, or make a specific appointment. completing all services on time will reduce the likelihood of inverter cooling system failure and hybrid inverter overheating.

What to look out for when dealing with Hybrid Inverter Coolant System issues

Not all hybrid vehicles require cooling systems for the hybrid inverter. Some do not become hot enough to need cooling, and others are cooled by fans only. It is important to understand which system your vehicle uses to prevent fraudulent services from being performed or billed.

Can I Flush and Refill the Hybrid Inverter Cooling System?

This is something the average DIY can accomplish, but only if the system is completely understood. It is not identical to an engine cooling system, but the flush, drain, and refill procedures are very closely related. If the proper instructions are available in the service manual, the proper coolant and flushing chemicals are on hand, and the used coolant can be recycled, this can be done by the DIY mechanic.