The sliding roof panel may close inadvertently due to the switch being triggered on accident. The switch and its bezel is not designed properly. Dealers will replace the roof console accessory switch trim plate free of charge to resolve the concern.
The rod connecting the brake pedal to the braking system may fracture, resulting in loss of vehicle braking. Dealers will inspect the vehicle and replace any affected bracket free of charge to resolve the concern.
The brake hoses may leak at the connection fittings to the front brake calipers. This can be caused by road salt and other road contaminants. The dealership will replace both front brake hose assemblies free of charge.
A switch that automatically controls the operation of the roof panel is not correctly recessed and may be activated accidentally. Any objects or passengers in the open roof area under closure may be crushed or injured as a result. Dealers will replace the surrounding switch trim to recess the switch and guard against accidental operation.
The ignition switch actuator can bind causing the ignition switch to stick in the "start" position. If this were to occur the actuator can unexpectedly release, cause the ignition switch to snap back into the "Accessory" position. This would cause the engine to turn off with an associated loss of brake and steering power assist. If these conditions were to lead to a crash the airbags may not deploy as expected. Dealers will inspect and replace the ignition lock housing as necessary to correct this concern.
The chassis electrical module can short due to internal contamination. This can result in the vehicle stalling. Dealers will replace the chassis electronic module free of charge to resolve the concern.
On the affected vehicles, the jam nut on the rear suspension toe adjuster link may not be tightened to the proper specification. A loose toe adjuster link could cause the vehicle to sway or wander at highway speeds and eventual failure of the link. Failure of the toe adjuster link will cause an abrupt change in the vehicle's alignment increasing the risk of a crash. Dealers will inspect the torque of both left and right rear toe link adjuster lock nuts, and replace the parts if there is evidence of damage or a loose link.
The engine may stall and fuel may leak due to overheating of the electrical terminals in the fuel pump module, resulting in the melting of the flange material. Dealers will replace the fuel module and fuel tank jumper wiring harness free of charge to resolve the concern.
The parking brake actuation arm may stay partially engaged when the parking brake is deactivated. This can cause the brake pads to stay partially applied and overheat, resulting in a fire hazard. Dealers will update the electronic parking brake software free of charge to resolve the concern.
The module that controls the functionality and operation of the air bags may have been set to "manufacturing mode" when leaving the factory. This would prevent normal air bag deployment from occurring in a crash. Dealers will reprogram the sensing and diagnostic module (SDM) free of charge to resolve this concern.