cheveronjim

Member of RepairPal since 2010

About cheveronjim

cheveronjim has not written a profile yet.

cheveronjim's Feed:

Questions

my trans thumps into gear at 2000rpms on 2nd 3rd after drivig 5 or 10 miles it smoothes out, but ...

when i drive my 97 saturn sw1 at about 2000 rpms (15 mpr)it shifts with a big thunk, and again at...

WHAT WOULD BE THE BEST PRICE TO REBUILD MY TRANSMISSION IF IT CAN'T BE FIXED EASILY? THE CHECK EN...

where can i get a rebuilt engine and have it removed ad replaced for as cheap as possible? in Las...

I have a OBD 2 scanner to reset my service engine light and find out what the codes mean.does any...

after car was stolen my drivers door lock won't unlock with the factory key. (i have to unlock th...

c.e.l. flickers and wouldn't pass smog first time, when i had shop check with obc 2, the codes th...

is there a way to read engine codes on a 98 gmc safari van? I know that I can read the codes on m...

the rear liftgate.latch on the drivers side won't release,so i can't open any of the bottom doors...

I RECENTLY HAD A BATTERY BLOW UP IN MY FACE AND I'AM VERY SCARRED OF THE PIECE OF JUNK NOW. I TR...

WHEN I BOUGHT THIS VAN ITS FUEL GAUGE DID NOT WORK. WHEN STARTING THE VAN THE NEEDLE GOES NUTS AN...

I RECENTLY STARTED HEARING TICKING TO A HEAVY THUMPING NOISES WHEN GIVING MY GMC SAFARI VAN GAS A...

I had my flywheel replaced, no flywheel noises now, but i have a deep knocking noise when i give...

I was installing a new interstate battery, and about 35 to 45 seconds after it blew up right in f...

on my 94 aerostar with frear drive i bought 5 years ago for $1000 with 94000 miles but now everyt...

what or where is a good place to have vacuum lines r&r all mine are ashed when touched so no air ...

is there a way to shim my starterm so it won't catch on my flywheel teeth? and what should it co...