Mannycanto

Member of RepairPal since 2017
About Mannycanto
Mannycanto has not written a profile yet.
Mannycanto's Feed:
Select a Category
QuestionsAnswersProblem ReportsReviewsComments
Questions
Security light on dashboard, how to turn it off, truck runs rough
When the security light turned on, I noticed it runs alittle rough like if it almost wants to tur...
I just had my NV3500 5 speed manual transmission rebuilt. How many quarts of synchromesh transmission fluid do I need to fill it to the right amount needed ?
I just had my 2001 GMC Sierra, 1500, NV3500 5 speed manual transmission rebuilt. How many quarts ...
How do I reprogram or reset a new ignition cylinder with key
I just installed one on my truck and all it does is turn over. And it seems like the new key and ...
When I connect the battery, the battery light stays on at the dashboard.
What is the issue. ?
I replaced the key cylinder but now I think the ignition stays stuck on the run
Position. Because I hear a grinding noise when the engine is running, when I press the brake peda...
If my starter is sticking because of the grinding noise I hear when I put
It in 1st, 2nd, 3rd, 4th, 5th or reverse. How do I fix that problem.?
When I shift into gear, it make a grinding noice, any suggestions would be
Greatly appreciated, thank you and it's hard to shift into gear
Do I have to take off the steering wheel just to replace the ignition switch
I put in a motor, but it doesn't want to start by itself, I did get it started by passing it thru...
After installing a new clutch kit, my clutch pedal goes all the way to the floor
Super easy without any pressure
I installed a motor into my pickup. But the new motor has oil cooler lines and
Mine didn't. Now what can I do or what are my options
I just installed a new clutch kit and the clutch pedal is very hard to press
Did I do something wrong or is that I need to start it up to get the hydraulic fluid flowing
I have the manual and installed it just like in the book, what else could it be.
I know that the tensioner only goes in one way
I put a motor from a 01 blazer into my 01 Sierra, but the belt doesn't fit,
Is there something I have to replace to make the belt fit
Can I replace a regular 4.3 motor with a 4.3 vortex. From a 2001 blazer into a 2
Into a 2001 GMC 1500
Can I put a motor from a 2001blazer into my truck. The blazer has a vortex
My truck doesn't have a 4.3 vortex but the blazer does
Answers
If you’ve got the answers, help others with their car issues.
Answer a question
Problem Reports
Got a car problem? Tell us about it! Report a car problem
Reviews
Is your car worth 5 stars?
Review your car
Comments
You haven’t left any comments. You can leave comments on questions and problems - when you do, they will show up here.
Get back on the road
Get back on the road
Research a car
Research a car
More from RepairPal
More from RepairPal