Question Answered: ENGINE VIBRATION
December 13, 2010, 11:25 AM
I would want to hook up my scanner and get the engine codes. This would provide a starting point. It could be a bad cam position sensor or idle control motor. We work on these types of issues all the time.
Question Answered: AC & HEATER DOES NOT BLOW AIR
December 13, 2010, 11:22 AM
Yes, its going to be the blower motor relay of the motor. It would need to be tested with a prob-tool and a good relay. The parts are avalable at an parts supplier and we can test if for you in a couple of minutes.
Question Answered: v6 misfiring intermittant
December 13, 2010, 11:19 AM
There is a gear in the distributer which can cause this problem. Also I would want to check fuel pressure underload, fuel injectors, timing and other tune up parts.
Question Answered: drivetrain
December 13, 2010, 11:11 AM
Sounds high....does you vehicle have an overdrive button? Drive train issues are one of our specialties so we would provide a free estimate.
Question Answered: Trans stuck in limp mode
December 13, 2010, 11:09 AM
Most automatic transmissions will go into limp mode when their is an internal problem. The OBD2 scanner would not help as you need to test and comand specific fuction within the tranny to determine the issues.
Question Answered: master clutch cylinder
December 13, 2010, 11:05 AM
Its a 3.0 hour job for a trained mechanic so I would say its some what diffcult. We specialize in this work so we can provide a complete estimate for free....just give us a call.