tramies

Enthusiast
98 points
Recent Activity

No activities found
Question Answered: How many axles are there on this vehicle?
June 11, 2015, 02:13 PM
Two wheel drive are two and four wheel drive is 4
Question Answered: blue/black smoke from exhaust how much to repair
April 16, 2015, 06:55 AM
Exactly what Hal said.....
Question Answered: whats wrong with my truck
March 24, 2015, 04:51 PM
Hal is correct.....Many things can make it die. It really should be diagnosed
Question Answered: battery goes dead in about 2-3 hours. brand new battery, key is off.
October 19, 2014, 10:04 AM
You can start by putting a "test light" between the "negative" battery post and the negative cable. Using the alligator clip, put it on the post and the test light on the cable. This after the cable is removed. If the test light "lights up" you have a draw. Start by removing each fuse, one at a time. Pull the fuse out and if it stays lit, put the fuse back. Keep doing that till the light goes out. Look at your owner's manual to see the fuse layout. If you have an amp meter, that would be better... http://www.wikihow.com/Find-a-Parasitic-Battery-Drain
Question Answered: Would you replace or rebuild a rear diff with 160k miles on it?
August 31, 2014, 01:03 PM
Your guy is correct. Save money and get a good used one. Audi's usually don't have diff problems
Question Answered: Lights on for 6+ hours. Charged several times, battery is new, car won't start..
March 07, 2014, 09:10 AM
Hal is right...Is it a AAA battery? Not quality battires! Tom www.pvgarage.com
Question Answered: wont start when warmed up, why?
February 08, 2014, 10:41 AM
An idle valve will not keep a car from starting. It controls air, not fuel or spark. ECU is very rare to cause an intermittent no start. You need to see if your no start is from lack of spark or fuel. Do you know how to do this? Do you have a test light? I would check for power on the coil with key on and then cranking. When not cranking, both sides of the primary side of the coil should be hot. when cranking, one side should stay hot and the other should pulse or blink. If both sides stay "hot" and don't blink, I would suspect a bad Hall sensor in the distributor...see http://www.youtube.com/watch?v=jJmqdhhduVc
Question Answered: Why it said service traction control
January 26, 2014, 07:39 AM
Exactly what Pushrod said. It has to be scanned to extract codes. Is it 4WD? The front wheel bearings can make the ABS light come on when they get excessive play. Also there are problems with the 4WD selector switch on the dash.
Question Answered: how do i get my key to go to the on position so i can take ignion lock out
December 08, 2013, 11:18 AM
Dumb question..Have you tried another key??? If yes... Professor G is correct. Don't do it yourself.
Question Answered: can you bypass the ignition security modual that plugs into the info
October 07, 2013, 12:44 PM
If it is an aftermarket system then yes
No activities found
No activities found
No activities found
Tramies's Shops