Heater Blowing Cold Air? Here's Why, and What to Do About It

Stephen Fogel
February 12, 2019

winter car

It’s freezing outside, and all you want is to get in your car and turn on the heat. You start it up and hit the heater. And you wait — and wait — but the heater just blows cold air.

There are many reasons your car's heater isn't working. Maybe the fan is malfunctioning. Perhaps your temperature gauge is running below normal. There could even be a puddle of liquid under the front of the vehicle.

A lack of heat can be a symptom of a much larger problem. You could soon be facing failing parts or even a blown engine. It’s important to understand the causes and get your car fixed before you’re stranded on the side of the road or faced with a pricey repair.

Here’s our guide to a poorly operating heater, what can cause it and what to do about it.

How your heating system works

It might sound a little funny, but your vehicle’s heating system is a part of its cooling system. The cooling system circulates a coolant through the engine that absorbs heat. That heated coolant then runs through the radiator, where the heat dissipates. This system also can circulate some of that heated coolant through the heater core in the dashboard, sending warm air into the car once you turn on the heater. The amount of hot air and which direction it blows are controlled by the buttons and switches on your dash, which direct the heater valves and the car’s blower fan.

Reasons your heating system isn't working

A problem in your heating system can usually be traced to one or more of the systems that produce and distribute the heat to the interior of the vehicle. These are:


Cooling system issues

Coolant level: If your coolant level is low, your heater core may not be getting enough warmed coolant through it to produce adequate heat. 

Solution: Top up the coolant and see if it helps. If the level is low due to a leak, track down the source and get it repaired. A coolant leak could indicate a cracked hose or loose clamp, or could stem from a more serious problem like a head gasket leak. Either way, don’t wait long to get it fixed — losing coolant is an easy way to overheat and destroy your engine.

And while we’re on the subject, it’s also important to keep your coolant fresh and clean. If you don’t, the helpful additives in the coolant will wear out and other particles will get into it, potentially clogging passages in the heating system. Check your owner's manual for the recommended replacement interval, and ask your mechanic whether your cooling system needs a change and a flush. It’s low-cost engine insurance.

Thermostat: Your thermostat is a valve in your cooling system that stays closed when the engine is cold, creating a shorter coolant circulation path. This makes the engine warm up more quickly and reduces emissions. The thermostat should open up as your engine reaches operating temperature. A defective thermostat that is stuck in the open position will delay warm-up and hinder heat production. 

A faulty thermostat can also make your temperature gauge read lower than normal and turn your check engine light on.  

Solution: Your mechanic can test the thermostat and replace it if necessary. You may be able to remove the thermostat yourself and test it by boiling it in water and seeing if it closes. But the process can be tricky and involves draining your coolant, as well. 

Air lock: An air lock is a large air bubble that forms in your cooling system as the result of a coolant leak or a recent coolant top-up. An air lock prevents the coolant from circulating properly and can cut your heat output. 

Solution: Set the heater to its maximum setting, remove the coolant tank cap and fill it to the proper level. Start the engine with cap still open and let the engine idle for a few minutes. If the coolant level should drop as the thermostat opens, top it up as necessary. This should bleed off the air bubble. When the engine is fully warmed up, put the cap back on and take a drive to see if the heat output has returned. 

Bad coolant hoses or loose clamps: Over time, coolant hoses can deteriorate, become clogged or get totally blocked. Also, the clamps that secure your hoses can loosen over time. A visual inspection of all the coolant hoses and connections will tell you if everything is secure. If you have an older car, check the hoses (with the car off) for a “spongy” feeling — this can mean they’re on their last legs.  

Solution: Replace all worn and suspicious-looking hoses (or have them replaced), make sure all clamps are tight, and check for leaks when you are done.

Radiator leak: This can keep your coolant level too low, especially in older cars. Look for puddles of coolant under the front of your vehicle. You may also find a dripping or wet area on the radiator. A bad radiator should be attended to promptly. 

Solution: Your mechanic might be able to repair the radiator, or it may need to be replaced.

Radiator cap: Your radiator cap regulates the pressure in the cooling system, acting as an escape valve if the pressure gets too high. If it sticks in the open position, there will be insufficient pressure in the system, and the coolant will not get hot enough, reducing the heater’s output. 

Solution: Just replace the radiator cap with a new one.

Water pump: The water pump circulates the coolant throughout the engine and heater core. On older vehicles, it can be a source of leaks and inadequate coolant circulation. 

Solution: Have your mechanic check the water pump to verify its condition. Replacement may be necessary if it’s not working right.

Engine fan: Most vehicles today have a thermostatically controlled electric fan that comes on when additional engine cooling is necessary. A defective thermostatic switch could make the fan run continuously, reducing the coolant temperature to the point where you can’t get enough heat into the interior. If the fan runs all the time, including from a cold start, you might have this problem.

Solution: Getting the thermostatic switch replaced should resolve the problem.

Heater core issues

Heater core internal passages: The heater core is like a miniature radiator built into the dashboard. It gathers heat from the warm coolant that circulates through it. But its narrow passages can become clogged from rust particles or other contaminants that can build when the coolant doesn’t get replaced or the cooling system doesn’t get flushed for a long time. 

Solution: Your mechanic can try flushing the heater core’s passages. If this doesn’t fix it, a replacement heater core may be needed.

Heater core exterior: The heat-radiating fins on the outside of your heater core could also be clogged with debris that makes its way in from the outside air intake at the base of the windshield. This can affect the heater’s output. 

Solution: If you can access the heater core, try cleaning the debris from the fins and the air intake passages.

Heater valve issues

Heater valves: These valves control the heat output of the heater core. They can be mechanical or vacuum-operated (like a rotary knob that you turn) or electronic (in electronic climate control systems with specific temperature settings). A valve that is stuck in the closed position will prevent heat from entering the cabin. 

Solution for manual valves: The mechanical or vacuum-operated variety can usually be repaired, with any defective components replaced. 

Solution for electronic valves: The electronic systems are more complicated, as they are usually integrated with the air conditioning system. Some troubleshooting by your mechanic can isolate the cause, which can be mechanical or electrical.

Blower fan issues

Blower fan: If your heater’s blower fan isn’t working, you won’t get much heat from the heater core to circulate into your vehicle. 

Solution: This can be as simple as a blown fuse, it could be a wiring issue, or the blower fan could need replacement. You can check to see if the fuse is blown and replace it, but your mechanic will likely need to intervene if it’s more complicated than that.

Stephen Fogel

About the Author

Stephen has been an automotive enthusiast since childhood, owning some of his vehicles for as long as 40 years, and has raced open-wheel formula cars. He follows and writes about the global automotive industry, with an eye on the latest vehicle technologies.

6 User Comments

Sign in to comment
By , November 22, 2017
84 Mercedes 300 TD no floor heat but it heats well. got any ideas GENE
By , February 26, 2018
Thanks for sharing such a useful info about the car problems which become common now a days. Still sometime we need car expert from gomechanic who repair our car at low cost and remain available even at mid night with free pick up and drop as per our requirement.
By , April 05, 2018
Thank you for explaining all the possible issues in terms that are easily understandable. I am on my second Jeep Liberty and both have had coolant issues. I lost my first one (2002) on the way to a job interview; overheated & blew the water pump & head gasket. The Jeep I drive now (2006) is showing signs of coolant issues. I've noticed that the heat starts to run cold, letting me know my coolant is running low. Once I refill it's fine, but I shouldn't be refilling the coolant as often as I am (3-4 days). I can't find any sort of leak, but it's obviously going somewhere. The weird thing is I can hear a rush of liquid when I first accelerate after starting up the Jeep, something I never noticed before with my last Liberty.
By , November 03, 2018
I don't know what size fuse for my heater for my 2005 dodge ram 1500
By , December 05, 2018
my 2009 Kia sportage has no heat OR ac AND I just got a new job and I have to suffer while driving!! I tried putting coolant in and that did nothing. to be honest i HATE driving because the belt is also squeaking too!! what else will go wrong?
By , January 21, 2019
my friend has a 1992 Plymouth acclaim 4-door 4 cylander the heater is not working at all. and he has no turn signals now but the fuses is good can some one please reply back and let me know what thease to ishues could be please ty