Jeep Compass Repair and Maintenance
A guide to problems, costs, maintenance and repair for your Jeep Compass
Never overpay. Check prices with our estimator
Verified by mechanics, reported by drivers like you
Ask a mechanic in our community
Our experts translate recalls into plain English
Jeep Compass ProblemsWater Leaks From the Front and/or Rear Roof Area
Water leaks may be noted from the front and/or rear roof area. Our technicians recommend to inspect the roof ditch and sunroof - Check all grommets and plugs, reseal roof seams, and replace the sunroof drain tubes if necessary.
A no crank or no start condition may develop due to electronic lockup of the wireless control module (WCM), also referred to as the Sentry Key Remote Entry Module (SKREEM). When this module fails the remote keyless entry system will also not operate. The WCM is commonly replaced to correct this concern.
A rattle type noise may be noted from the AC compressor or the compressor could be damaged due to "slugging" of the refrigerant. The compressor may require replacement to correct this concern. If the compressor is replaced an updated condenser may also be required.
Jeep Compass Questionsim only getting heat out of the far left ports selector is working what is prob (1 answer)
selector is working fine just only have heat coming out of far left ports
Very dangerous in traffic.
When you step on the gas pedal it hesitates during acceleration. Does it sound like fuel filter needs changes or spark plugs?
Jeep Compass RecallsAir Bags And Restraint Systems Disabled In An Accident
The occupant restraint control (OCR) module may short circuit and prevent the vehicle's restraint system from operating in an accident. Dealers will repair the vehicle (a procedure for this repair is still under development at the time of this writing) free of charge to resolve the concern.
The power steering low pressure return hose may leak from a mis-installed clamp. Dealers will inspect the clamp and adjust it as necessary free of charge to resolve the concern.
522 vehicles equipped with a 2.4L engine are being recalled because the engine may have abrasive debris in the balance shaft bearings. The debris can result in premature wear and loss of engine oil pressure. As a result, the engine could stall unexpectedly or fail. Dealers will replace the engine balance shaft module to correct this concern.