The clutch may fail prematurely requiring replacement. It has been recommended by some that a high quality aftermarket replacement clutch may provide increased longevity over a clutch purchased from the dealer.
Problems for specific Mitsubishi Lancer Evolution years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Most reported Mitsubishi Lancer Evolution problems
Erratic HVAC blower motor operation may be caused by a failed blower motor and/or blower motor resistor. Our technicians tell us that if the blower motor resistor fails the blower motor should be checked. If the blower motor fails its functional test in should be replaced along with the failed blower motor resistor.
An engine overheating condition may develop due to a failed radiator cooling fan controller. The failed controller should be replaced to correct this issue.
The crankshaft position sensor may fail causing a stalling can/or no start condition. Replacing the faulty crankshaft position sensor should correct this condition.
The automatic transmission may fail prematurely. Transmission overhaul or replacement may be necessary to correct this concern.
t is not uncommon for the clear coat paint to develop white spots and begin peeling. In most cases Mitsubishi will not cover out of warranty repairs for this condition.
There have been reports of airbags not deploying in the event of a frontal impact. Some claim that a shorted airbag wire harness can cause this to occur. Unfortunately there is no diagnoses that will isolate this problem other than fault codes stored in the airbag control module. Our technicians recommend to have any airbag light issues diagnosed and repaired in order to help ensure the airbags will deploy when needed.
The heating, ventilation and AC (HVAC) temperature control knob may be hard to turn. Mitsubishi Motors has released a service bulletin out outlining the necessary repairs. Repairs involve installing a new air blend door lever and link, lubing the blend door track, and installing a filter on top of the blower motor housing to prevent entry of dirt and debris. If the temperature control assembly has been damaged it will require replacement also.