Mitsubishi Endeavor Problems

RepairPal has identified the most common problems with the Mitsubishi Endeavor as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
Choose your vehicle
Known Problems

One or both side airbag modules may fail resulting in illumination of the airbag warning light. Side airbag modules determined to be faulty should be replaced.

The automatic transmission may develop a 2-3 shift flair. This is commonly caused by an internal fault related to the reverse clutch assembly. Replacement of the rear housing and reverse clutch assembly may be required to correct this concern.

The Check Engine Light may illuminate with no fault confirmed. Our technicians tell us a powertrain control module (PCM) software update is available which may correct this concern.

There have been reports of airbags not deploying in the event of a frontal impact. Some claim that a shorted airbag wire harness can cause this to occur. Unfortunately there is no diagnoses that will isolate this problem other than fault codes stored in the airbag control module. Our technicians recommend to have any airbag light issues diagnosed and repaired in order to help ensure the airbags will deploy when needed.

The Check Engine Light may illuminate due to one or more engine vacuum leaks. Our technicians tell us these leaks can be caused by damage to seals and/or vacuum hoses as a result of to much ethanol content in the gasoline. Affected hoses and seals must be replaced to correct this concern.

The brake pedal may pulsate when the brakes are applied. This is most commonly caused by the front brake rotors warping. Resurfacing the affected rotors may correct the problem for the short term but replacement would generally considered a longer term solution.

The drivers power seat may not adjust properly or develop a noise issue when adjusting. This is commonly caused by a damaged drive cable which will require replacement.

The drivers seat may not adjust due to a broken adjuster cable. The failed cable must be replaced to correct this concern.

A noise may develop from the steering column, this is commonly caused by the turn signal cancel cam which may require replacement.