Close

Kings Auto and Truck Repair

Apprentice 7fcc12909ae64520525213c612d1ef7ee84ad402e611d9a259270b15abea875bApprentice
181 points
A.S.E. Certified Master Technician for 35+ years
Recent Activity

No activities found
Question Answered: Cant start the car
December 11, 2017, 06:39 AM
Key fob may not be programmed to the vehicle.
Question Answered: my 2011 Traverse will not turn over, after replacing the battery.
November 19, 2017, 09:03 AM
Sounds like a low voltage issue. The alternator is probably the cause , but after changing the battery it should have turned over and started.Though it may not have run for more than 15-20 minutes it would have died again. I would begin by looking at the negative battery cable where it attaches to the engine, make sure it is still attached and tight connection. Second thing to test is the voltage at the battery compared to at the starter when trying to crank the engine as a bad battery cable or a faulty connection will cause the symptoms described.Hth's
Question Answered: how do I fix my dome light. When I hit a bump it flickers
November 05, 2017, 06:35 AM
REmove the light cover and tighten the mounting screws
Question Answered: I put in a new ignition switch and now the car starts but wont stay running
November 02, 2017, 07:00 AM
When replacing the ignition switch it has to be re-learned as it is an anti-theft device.This can be done by you.Put a battery charger on the battery, turn the key to the run position, look at the security light, when it goes out after about 10 minutes turn the key off then back to the run position, wait another 10 minutes until the light goes out, turn the key off , then back to the run position a third time, wait for the light to go out then crank and start the vehicle.HTH's
Question Answered: No air blowing out of vents
October 22, 2017, 11:04 AM
Sounds like a failed mode door motor.The motors are a high failure rate item.
Question Answered: My heater A/C control works only in the high positon or the 4th position.
October 22, 2017, 11:03 AM
99% of the time it is a failed blower resister.
Question Answered: How do I replace a reverse light switch on a manual transmission 2010 Chevy HHR?
October 22, 2017, 11:00 AM
Buy a new switch ,find the one on the side of the trans that looks like the new one and remove and replace it with the proper sized socket, do not use an open end wrench or the switch will be damaged. Put thread sealant on the new switch prior to installation. Torque to 24 inch pounds or snug.
Question Answered: Turn signal not working, on 2000 Olds Alero.
October 08, 2017, 04:35 PM
The hazard switch is usually at fault for this problem.
Question Answered: How do you shut the 4 wheel drive off
September 29, 2017, 10:19 AM
The 4 wheel drive unit does not "use" trans fluid.If you are losing trans fluid it needs to be inspected for a leak. Shutting off the 4 wheel drive will not change your fluid loss.
Question Answered: I have a 2010 mercury milan and my break master cylinder was just replaced
September 21, 2017, 08:54 AM
Brake system may need to be bled with a scan tool.
No activities found
No activities found
No activities found
Kings Auto And Truck Repair's Shops