Rookie cbe0621eac06868b3efe0d8d1d3611e23c60d3114864ea2ec19a68cfbd3eebabRookie
45 points
Recent Activity

Question Asked: Driver's side power seat and adjustable pedal is not working. What needs to be f
June 05, 2012, 09:01 AM
I have checked all the fuses and they are good.
Question Asked: Power Seat Not working
May 29, 2012, 10:17 AM
The driver's side power seat is not working. this vehicle has the memory switch. Are there any common issues that would apply?
Question Asked: 95 Ranger RWD rotor replacement
May 03, 2012, 11:13 AM
I have to replace the rotors and pads on our 95 Ford Ranger RWD std cab with 2.3 L 4cyl, manual transmission. what all is involved in doing so? I have been told the front wheel bearings need to be repacked at the same time.
Question Asked: 2000 F250 4WD 5.4 V8. I need to change the oil pressure switch and check presure
December 14, 2011, 01:44 PM
where is the sending unit located on this vehicle and what is involved in replacing it?
Question Asked: 2000 Ford F250 5.4 V8 Oil Pressure
December 14, 2011, 11:12 AM
On overnight startup during cold weather the oil pressure reads zero but does pick up. There is no engine noise or knocking that accompanies this issue. The oil pressure guage will eventually go to normal operating range usually within a minute or so. My thoughts are a guage sending unit. Are there any other ideas? What is the procedure for replacing the sending unit?
Question Asked: Radiator overflow repair
October 02, 2011, 04:44 PM
I have a 1995 jeep cherokee with the 4.0 6 cylinder. When i was checking the radiator cap the overflow tube came loose. I went to reattach it only to find out the fitting had broken in two ans there was no way to reattach the tube. This is a plastic piece. Is there a way to repair the plastic part the overflow tube connects to?
Question Asked: 1995 Ford Ranger Check Engine Light and Scanner port
September 25, 2011, 04:15 PM
The check engine light came on. There is a diagnostic port under the dashboard near the driver's door. My question is this a OBD II port or is it a OBD port. The port is 16 pins but it appears only 6 are in use. What scanner should be used on this vehicle?
Question Asked: Front End Vibration
February 24, 2011, 06:59 AM
My F250 Supercab 4 WD has developed a heavy vibration. It has really gotten bad and now starts at about 40 mph and continues until over 80 mph. It seems to be coming from the left side and the vehicle has started to pull to the left. I had the front wheel balanced with no change. Any thoughts?
Question Asked: Spark Plug change
December 25, 2010, 07:45 PM
Will changing the spark plugs on my 2000 F250 5.4 V8 eliminate spark plug ejection problems? This vehicle has 115,000 miles on it and runs very well but I do not think OEM plaugs were ever changed.
No activities found
No activities found
No activities found
No activities found