35 points
Recent Activity

Question Asked: After car warms up to temp it shutters and shuts off, after cool down starts aga
May 18, 2013, 11:02 AM
I pluged my OBD2 scanner into the ECM port. Icon shows connected to OBD port but unable to retrieve MIL codes. Check engine light does come on with ignition turned on. I didn't run a scan on the road test yet. Car does run slightly ruff. Sometimes hard to start. Fuel, fuel pump and air filter replaced. Scratching my head??? Systoms seem to be like a bad coil but not famalier with the 4 cyl. Trying to help a friend. Is ther a ignition control module? (ICM)
Question Asked: ignition module ICM located ?
May 16, 2013, 10:17 PM
I cannot seem to find the location of the ICM!
Question Asked: where is the ignition control module located ?
May 16, 2013, 10:09 PM
car runs down the road till temp starts getting up to temperature and then shuts down and takes a while to restart. It does run a little ruff slightly.
Question Asked: where is the engine coolant temperature sensor on a 2006 Dodge Ram 1500 3.7L
May 08, 2013, 09:28 PM
I received a PO117 code and is (Engine Coolant Circuit Low input) I am not sure where the ECT is located on the 3.7L magnum engine?
No activities found
No activities found
No activities found
No activities found