1tiredtech

Member of RepairPal since 2012

About 1tiredtech

ase master tech since '82,safety and emission inspector,taught classes at local comm.collage

1tiredtech's Feed:

Select a Category

Questions

have good spark,fuel,150#compression.has set p300 and p101 codes.did swap out maf with known good...

Answers

take belt off and spin each pulley-might have a bearing in a pulley going bad-auto tensioners not...

sounds like front hub bearing assembly.good chance it's the right side-bears more weight when tur...

is the check engine lite on? if so,may have code for APP sensor 1&2(gas pedal sensors)have change...

i own 4 toyotas;front calipers are 4 piston design,chances are at least one or two are sticky.if ...

lightly step on brake and see if noise goes away.may have worn caliper hardware or loose pads.

that size is about 3plus sizes over-good chance they'll rub strut/spring seat.

I would also remove serpentine belt.Those belts have enough gripping area to lock up motor if a p...

Did you have engine light scanned for codes? A bad air/fuel ratio sensor(aka upstream oxygen sens...

may need scanner to activate autobleed mode on abs unit

Problem Reports

Got a car problem? Tell us about it! Report a car problem

Reviews

Is your car worth 5 stars?

Comments

You haven’t left any comments. You can leave comments on questions and problems - when you do, they will show up here.

Get back on the road

Get back on the road

Research a car

Research a car