dpasek
Member of RepairPal since 2012
About dpasek
dpasek has not written a profile yet.
dpasek's Feed:
Select a Category
Questions
Our community of professionals is here to help you with your car questions.
Answers
You have to set base timing to 0 degrees by disconnecting a certain wire. See another post of mine.
VIN 'W' engines can get fuel leaks at several places. Most likely are the fuel pressure regulato...
Do you get a Diagnostic Trouble Code 45? If so, you might have a fuel leak in the intake manifol...
Code 32 is probably caused by a piece of carbon stuck in the EGR valve causing the pintle to stic...
Salvage yard. Look for 'BBNT'. But if you don't have your base timing set yet, don't blame the ...
Use a torque wrench next time, and look up the torque spec in the shop manual.
There is an electrical barrel connector midway behind the upper edge of the carpet on the passeng...
It is an electric motor and is located on the driver's side of the transfer case, tucked in next ...
Remove the electric mirror adjust switch from below the dash (if it is there) - 2 screws - let it...
Mine has just over 200K now and I have had it for about 4 years and 60K miles. I have had to do q...
You shouldn't have to. You should be able to engage and disengage 4 High while you are driving. ...
Inside the digital cluster, there is a power supply module for all of the blue vacuum fluorescent...
Problem Reports
13 reports, 4 comments on this Chevrolet S10 Blazer problem
12 reports, 4 comments on this Chevrolet S10 Blazer problem
Reviews
Is your car worth 5 stars?
Review your carComments
You haven’t left any comments. You can leave comments on questions and problems - when you do, they will show up here.
Get back on the road
Research a car
More from RepairPal
More from RepairPal