2010 Toyota Corolla Problems

RepairPal has identified the most common problems with the 2010 Toyota Corolla as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
×
Choose your vehicle
10
Known Problems

At higher mileages, (125,000-150,000) the automatic transmission may not shift correctly. This can be caused by the throttle position sensor being out of adjustment or a shift solenoid needing to be replaced. Typically the transmission does not need to be completely overhauled.

There are occasional reports of daytime running light problems.

The Check Engine Light may illuminate due to an evaporative emission (EVAP) system fault. Our technicians tell us these EVAP system faults can be difficult to diagnose but it is not uncommon to find a failed charcoal canister or a loose or worn gas cap.

The head gasket may fail due to a defect in manufacturing of the cylinder block.

On this vehicle, the head bolts are known to pull the threads out of the engine block, allowing the head to slightly lift, and causing head gasket failure. Symptoms may include:

  • Overheating
  • White smoke from exhaust
  • Rough running conditions and/or inability to start or idle
  • White or cream colored oil on dipstick
  • Check engine light 
  • OBD Trouble Codes P2181, P0300

When the head gasket fails, the bolt holes for the head bolts must be repaired before the cylinder head can be remounted. 

This issue is not always preventable, but to help avoid it, never run the engine if the engine temperature is ever above the normal range. 

Drivers of the Toyota Corolla may notice excessive oil consumption between oil changes, even to the extent of the engine oil warning light displayed on the multi-function display.

This issue is known to be caused by infrequent oil changes causing engine sludge, or worn piston rings. 

The engine should be cleaned of oil sludge, and if oil consumption remains excessive, the engine may need new piston rings, or other internal components replaced. 

To avoid this issue, change the engine oil and filter every 3,000 miles, and ensure the proper grade of oil is used. 

The mass air flow sensor on higher mileage cars occasionally needs to be cleaned or replaced if sluggish acceleration is experienced or the Check Engine Light is illuminated with a mass air flow meter sensor fault code stored.

The engine mount on the passenger side of the car can wear out on cars with high mileage. This will put extra stress on the other mounts and the faulty mount will need to be replaced.

The rear Oxygen sensors are a critical element in fuel control (unlike other vehicles) and can cause an emissions test failure for high CO and HCs. The sensing element cracks and and reports an erroneous steady state lean condition which confuses the engine computer.

The bolts attaching the front door window glass to the window regulator may come loose. This can cause the window regulator to become damaged and possibly causing the window glass to break. Some 2003 & 2004 models have been recalled for the issue.

At higher mileages, an anti-lock brake system wheel speed sensor may wear out and illuminate the ABS warning light. It is recommended to replace the sensor with a factory part and be sure to clean all rust and debris from the mounting area because the mounting distance is critical. Failure to do so may result in the new sensor setting false trouble codes.