1995 Mercury Villager Repair and Maintenance

A guide to problems, costs, maintenance and repair for your 1995 Mercury Villager

The distributor shaft bearing can become rusty, and seize causing the engine to stall or not start. The failed distributor will commonly require replacement.

The fuel injectors can fail and cause drivability problems. Often there is no Check Engine light and the failures can be caused by corrosion of the connector, clogging beyond the point of cleaning, and/or internal failures.

The exhaust manifold often warps and cracks, breaking off the studs between the cylinder head and the exhaust manifold. A ticking type noise may be noted most noticeable when the engine is cold.

See More Problems 4

For instance: im going downhill good, all at once the gas pedal isnt doing anything, then it works again, going uphill is even worse. Although, ive used my vehicke for weeks with no problem, then starts doing that again, I dont know why, I need your help.

I had been in bumper to bumper traffic on a freeway. When I got to the exit ramp oil light came on and engine began to sound like a diesel. Pulled over waited approximately 2 hours for engine to cool. Checked and oil level was fine. Started the vehicle and was driving down the road engine just st...

My air filter compartment does not align and seal because the plastic side & bottom is warped. Consequently, i have large gaps on the side and bottom of it. I can even see the filter inside. Does this affect the cars performance? My car runs rough when I put it in gear (chug chug, shake like ...

See More Questions 41

VEHICLE DESCRIPTION: MINIVANS. THE FUEL TANK VENT HOSE ALLOWS AIR TO VENT FROM THE FUEL TANK DURING REFUELING. CRACKS HAVE DEVELOPED IN THE VENT HOSE. IF (1) THE FUEL TANK IS OVERFILLED, NOT ALLOWING EXCESS FUEL IN THE VENT HOSE TO FLOW BACK INTO THE TANK, (2) THE VEHICLE IS DRIVEN ONLY A ...THE REAR LAMP SOCKET MAY NOT ILLUMINATE BECAUSE THE METAL CAN IN THE LAMP SOCKET MOVES OR SEPARATES FROM THE PLASTIC SOCKET HOUSING.AN OUT-OF-SPECIFICATION CONDITION IN THE SEAT CABLE ROLLER PULLEY ASSEMBLY CAN ALLOW THE CABLE THAT CONNECTS THE SEAT ADJUST LEVER TO THE LATCH TO BE PINCHED IN THE ROLLER ASSEMBLY.

See More Recalls 3

Had this car since it had 10,000 mi on it and it has done well as it now is approaching 200,000. the ignition key switch was replace by a dealer and continued to be a problem to this day. Heater/AC controls for the rear had a bad ground the dealer couldn't fix (still bad after 12 years). Presently battery light flickers, ABS light comes on and off, and battery charging is not dependable now....

owned the 95 villager for a year now and i find it good on gas and easy to handle. for it's age and over 255thou km it is holding up very well. just having a problem with air flow sensers but otherwize normal maintainance.

See More Reviews 2