Close

2000 Toyota Solara Problems

RepairPal has identified the most common problems with the 2000 Toyota Solara based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

No car image 94a1663db56199c5353592009e34aaa51078a2469bed068bb8d6f0ba43accf97
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more
6
Known Problems

Intermittent failure of a purge control valve in the evaporative emission system can cause the Check Engine Light to illuminate. A failed valve should be replaced to correct this problem.

 

On higher mileage vehicles, an engine misfire may develop and/or the Check Engine Light may illuminate due to a failed ignition coil. It is not uncommon to replace all the coils when the first one fails in order to prevent return trips to the repair shop.

Sludge can build up in the engine because Toyota did not recommend frequent enough oil changes. Lexus will sometimes offer a discount on cleaning the engine if necessary. Owners who changed their oil every 3,000 miles did not experience these problems. This sludge build up can lead to excessive oil consumption.

The Toyota Solara 2.2L 4 Cylinder and 3.0L V6 engines have a known issue with the valves that if left unchecked, will cause burned valves and engine performance issues. 

The engine ‘breathes’ through valves that are pushed open by the camshaft, and closed by springs. When valves are closed, they seal against a valve seat. In this vehicle, the valve seat is too soft, so after the valve contacts it thousands of times, it becomes crushed. Once it is crushed, the valve can no longer make a proper seal, and the valves erode due to extreme temperature (burnt valve).

Symptoms related to this issue:

To repair the burnt valves, the cylinder head must be removed and rebuilt, which is a costly internal engine repair, however, this issue can be prevented through inspection and adjustment of valve clearances every 40,000 miles.

The Check Engine Light may illuminate because a component of the oxygen sensor stops working. As a result the engine computer is unable to determine the proper ratio of air to fuel for the engine. Replacing the failed oxygen sensor should correct this concern.

Debris can get into the idle air control valve. This will restrict the air flow into the engine, causing idle speed and/or stalling when cold. The valve can be cleaned or replaced to correct this concern.