The crankshaft position sensor may fail. Symptoms of this are: The engine will crank—but not start—especially when the engine is warm. The car may start again if it is left to cool off, but it may run roughly or have poor performance.
Car problem reports
Problem with your car? See what our experts say or submit your own.
Most reported 2005 Mercedes-Benz CLK320 problems
An engine Oil leak may develop from the PCV vent housing on the valve cover and/or the inspection plate on the front of the engine.
The ESP and BAS warning lights may illuminate due to a failed brake light switch. Replacement of the failed switch should correct this concern.
Cup holders in the dash are known to break requiring repair or replacement.
The electrical connector at the automatic transmission may leak fluid. Over time leaking fluid could migrate through the wiring harness and damage the transmission control module. If that happens a new harness and control module may be necessary to correct the problem.
A vibration felt through the center floor of the vehicle can be caused by cracked and/or shredded driveshaft flex discs, resulting in excessive driveshaft movement. If not repaired, damage to the driveshaft center support bearing, transmission, or differential can occur.
Leaks may develop from the differential cover and/or seals on high mileage or older vehicles. Our technicians recommend a complete reseal of the differential unit if these leaks are addressed.
The rubber bond in the harmonic balancer can decay, which causes the balancer to move and work its way toward the timing cover. If the balancer comes into contact with the timing cover while the engine is running, it will fracture and damage the cover and potentially other surrounding parts. The harmonic balancer should be inspected at every service.
An engine oil leak may develop from the oil level sensor. Replacement of the leaking sensor will commonly correct this concern.
Torque thrust bushings in the front suspension may crack and leak oil, this causes steering alignment problems and excessive tire wear. Another symptom of a worn bushing is a clunk or thud noted when turning, on hard acceleration, or hard braking.
Going over large bumps in convertible models may cause the roll bar to deploy, rendering the roof inoperative. Special tools are generally required to return the roll bar to its stowed position.
Computer control modules for the seats and doors, the CD changer, and the brake lamp switch tend to fail.
A repetitive clicking noise from behind the center area of the dash panel is usually caused by a broken stepper motor actuating arm. The actuating arm controls the direction of air flow in the climate control system. Disassembly of the center console will be required to access and change the broken arm with the updated, reinforced part.