Problem Reports

The crankshaft position sensor may fail. Symptoms of this are: The engine will crank—but not start—especially when the engine is warm. The car may start again if it is left to cool off, but it may run roughly or have poor performance.

The instrument cluster display may lose pixels and need replacement. However, if the back lighting bulbs for the odometer display in the center of the cluster burn out, they can be replaced.

An engine oil leak may develop from the oil level sensor. Replacement of the leaking sensor will commonly correct this concern.

A vibration felt through the center floor of the vehicle can be caused by cracked and/or shredded driveshaft flex discs, resulting in excessive driveshaft movement. If not repaired, damage to the driveshaft center support bearing, transmission, or differential can occur.

When the engine is running, but the vehicle is not moving, a rattle heard from beneath the vehicle could indicate that one of the exhaust catalytic converters has failed. The substrate (the internal part of the catalyst that reduces emissions) can loosen and bounce around inside the canister section of the converter—the defective unit will need to be replaced. If this problem is ignored, the substrate can break down and reduce to a size that plugs the outlet pipe, which will cause a sudden loss in power.

As a way to increase braking performance, the brake pads and rotors are make of a softer material and may be in need of replacement after approximately 20,000 miles; owners should be vigilant about getting their brakes checked.

One or more of the following steering linkage components may wear prematurely;  tie rod ends, drag link, or idler arm. Our technicians remind us the wheel alignment should be checked and adjusted if any of these items are replaced.

The evaporator temperature sensor can fail, causing the AC compressor not to cycle. If the AC compressor does not turn on, the AC system will not blow cold air. If the compressor is stuck on, the air will be very cold at first, before warming up.

Cables in the convertible top tend to break. If the convertible top stops operating prior to reaching the desired open or closed position, the micro switches that sense the position of the top may have failed.

The mass air flow sensor tends to fail causing poor fuel economy and Check Engine light illumination. The engine air filter should be replaced when the mass air flow sensor is replaced; a dirty filter can allow debris to damage the new sensor.