robert paul andrews

Rookie cbe0621eac06868b3efe0d8d1d3611e23c60d3114864ea2ec19a68cfbd3eebabRookie
29 points
Recent Activity

Question Asked: head gasket set for 1999 malibu 3.1, and intake gasket set
August 09, 2014, 09:35 PM
any on-line stores that can top advance or regular auto parts.any machine shops that deal in full gasket sets,Sincerely
Question Asked: price quote on a four cylinder gasket set for rebuild kit with bearings n rings
August 09, 2014, 09:28 PM
motor may have jumped time,i am a mechanic but havent seen the motor and mdont know if it has a timing chain or belt.just a quote on the full gasket set and full bearings and rings.anyone know of any special outlets or machine shop that can top an advance or auto-zone, etc.thank you
Question Asked: average price for all gasket rebuild kit
August 09, 2014, 09:05 PM
i may be rebuilding this dodge 4 cylinder truck.what is the average price on the whole gasket set,or rebuild kit with rings and bearings.and does this engine have a timing chain or belt?sincerely Robert p.s it isnt locked up but think oil pump may have failed.havent torn it down yet,but a price quote on above items would be good.Thank you.
Question Asked: ther is watr leaking at rear of enginebetween the head& the ithead gskt
August 09, 2014, 08:59 PM
do you think it could just be the rear head gasket blown,no water in oil or no steaming,it runs did overheat.think maybe the head gasket is is leaking right between head and block,pretty heavy while running.and are the heads aluminum thank a mechanic,rareky have i seen water pour between head and block,without a much are the gasket sets for head and intake?
Question Answered: replaced throw out bearing now have no fire to coil
August 09, 2014, 09:22 PM
i would say you have a set of wires un-plugged or you cut a wire or a loose grnd say you pulled something loose.sounds like you about have it.dont let it get you mad.take a little break then look it back sounds simple ,check plug ins on trans and anywhere near transmission.u will find it.
Question Answered: would the clutch safety sensor stop the motor from firing ????
August 09, 2014, 09:16 PM
how do you push it in manually?if it is connected to the clutch pedal,then that would serve the same purpose as if it wasnt broken,otherwise if it is turning over if you push it in with your fingers or however then it would not or should not keep it from firing.if it was running and then the switch broke and cant be pushed in by the pedal,and then it stopped running,then their may be some kind of relation to the switch.cross the wires goin to safety switch and try but dont leave it rigged if it runs.may cause may not be able to see if the contact in the switch is touching if you dont cross the wires or make the connection for the switch.switch could be bad also,so try jumpin the wires one to the other and check it
No activities found
No activities found
No activities found