Question Asked: wont start
May 10, 2011, 07:02 AM
I just replaced the crank position sensor. 2.2 4 cyl still wont start. turns over good - gas is coming out from throttle body fine - nice little mist - but no spark or sometimes a backfire type sound as its turning over. ?? Thanks for any advice. Bob
Question Asked: lift kit install
April 24, 2011, 03:19 PM
If anyone out there has had experience in installing a 3.5" lift kit on a 1998 2 wheel drive jeep grand cherokee I sure would appreciate any helpful hints before my kit arrives in the mail next week. ROcky Mountain says its a fairly simple install, but if anyone has run into any issues and would be willing to share I sure would appreciate it. Thanks. Bob
Question Asked: how do I replace the crankshaft position sensor on my 1991 4 cyl beretta?
April 24, 2011, 03:14 PM
I'm sure I need to replace the crankshaft position sensor/modul on my 1991 4 cylinder 2.2 beretta. I was told I may need to drop the oil pan to pry it out from the inside!! IS my neighbor just trying to scare me? Is this seemingly simple fix a nighmare waiting to happen?
Problem Reported: Car Won't Start Due to Ignition Coil/Crankshaft Position Sensor Failure
September 15, 2010, 10:06 PM
<!DOCTYPE html PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN" "http://www.w3.org/TR/REC-html40/loose.dtd">
<html><body><p>The <a id="ce_9152" class="ct_glossary tooltip" href="/ignition-control-module">ignition module</a> or <a id="ce_5829" class="ct_glossary tooltip" href="/crankshaft-position-sensor">crankshaft position sensor</a> may fail causing the engine to die and not restart. Diagnoses will be necessary to determine if the module or crank sensor is causing the no start condition.</p>