Question Asked: coolant in oil
January 03, 2010, 09:14 PM
Just rebuilt engine- runs but rough shut it down.
coolant in oil
Heads were reconditioned, new gaskets, thermostat was replaced.
exhaust was light blue/steamy
Is this a cracked block or head
Question Asked: head casting #
December 25, 2009, 10:40 AM
Where do I find the head casting numbers? I'm going to get the heads rebuilt and the shop wants those numbers and if the rockers are 8 or 10mm, how do I find out that?
Question Asked: intake manifold
December 23, 2009, 08:03 PM
were can I purchase a lower intake manifold?
Web, mail order, dealer, local around Orlando, Florida
Question Asked: oil leakage
December 23, 2009, 07:58 PM
Any known problems about oil leakage in the oil filter area?
Oil is leaking (1 quart per day) in the oil filter area. Could it be the oil filter cover gasket oil maybe a loosened oil filter?
Question Asked: wet cylinders
December 23, 2009, 07:51 PM
how do I dry out a cylinder? A squirt of starting fluid and a bar-b-que lighter?
Question Asked: no spark
December 20, 2009, 05:17 PM
car will not start, NO SPARK. new wires and plugs just put on.
Question Asked: blown radiator hose
December 15, 2009, 10:41 AM
I blew the hose on e-way, air filter (high performance) sucked water into engine, saturated!!!!!!! I tried to start after repaired hose-first with out plugs to blow out water, tried again plugs were saturated again. I had a water leak between intake manifold & head prior to this. warped head?
Question Answered: acceleration hesitation
December 15, 2009, 10:33 AM
95 buick lesabre; when hot hesitation on accelaration. I've replaced EGR, crankshaft sensor, fuel pressure reg., still trouble nothing changes performance HELP