46 points
Recent Activity

Question Asked: why is my brake pedal vibrating when i apply the brakes?
August 18, 2014, 08:49 PM
When i was told the brakes were shaking while cornering, i took it for a test drive and no shaking during hard braking. But when braking during a left turn the brake light came on as a grinding noise was herd. I inspected the brakes but found no appearant problem. Could this be a strut or tie rod problem?
Question Asked: Why isn't my ac charging or getting cold? I think my compressor burnt out.
August 01, 2014, 03:35 PM
I recently tried to recharge my ac with the recharge bottles sold at Auto Zone and it did not get cold. So I added more. Thinking I may have over charged the system, I released all the pressure from the low charge valve then recharged to proper pressure level. Driving 30mi in 100+ degree heat the system did not get cooler, instead the compressor started smoking! And now sounds racketing.
Question Asked: How do I change the front hub bearings on a 3/4 ton 4x4?
April 26, 2014, 01:12 PM
The front hubs were converted to part time 4x4. They now need new bearings.
Question Asked: How do I change The inner tie rods on my 2002 mercury sable?
January 27, 2014, 09:49 AM
There is a knocking sound comming from the front end of the car while turning and a squeaking when i turn the wheels when parked and at low speeds.
Question Answered: runs rough after warm...replaced plugs, fuel filter, egr, putinjector cleaner in
August 18, 2014, 09:55 PM
I suggest cleaning the MAF sensor and the throttle body with the proper cleaners, also the idle air control unit.
Question Answered: how to replace heater hoses
August 18, 2014, 09:47 PM
Youll find very helpful videos on youtube.
Question Answered: Where is my A/C heater blower motor resister located on my 1992 Chevrolet S10
May 15, 2014, 03:02 PM
The "squirrel cage" or blower fan is located on the fire wall behind the dash board on the passenger side. Your problem sounds like it could be a problem with the blower speed switch. I encounterd this same problem on a 2007 Z71. I simply swapped out the entire climate control unit from a doner truck.
Question Answered: backfiring through intake, rough idoling, burning rich what do you think
April 26, 2014, 01:19 PM
Sounds like your fuel/air ratio is running a little rich. You may want to also change out the EGR and PVC valves.
Question Answered: the inside release for the gas cap and trunk lid no longer is operating. success
January 27, 2014, 10:53 AM
It might be a burnt fuse. Locate the fuse panel, look on the underside of the fuse panle cover and find the trunk/fule door and corrisponding number. locate the fuse on the panel, pull it out and check to see if the fuse is burnt.
Question Answered: where is located mass airflow sensor? what is means P0100 code error? ??????????
January 27, 2014, 10:41 AM
The Mass Airflow sensor would be located on the throttle body or between the trottle body and intake manifold.
Problem Reported: Problem With Idle Air Bypass Valve May Cause Engine Performance Problems
May 27, 2010, 11:07 AM
<p>If you experience difficulty starting the engine when cold, stalling at idle, or hesitations during acceleration, it may be the <a id="ce_10166" class="ct_selected tooltip" href="/idle-air-bypass-kit">idle air bypass valve</a>. This valve helps the vehicle idle steady when the accelerator pedal is not pressed.</p>
No activities found
No activities found