Rookie cbe0621eac06868b3efe0d8d1d3611e23c60d3114864ea2ec19a68cfbd3eebabRookie
45 points
Recent Activity

Question Asked: AC system
February 10, 2010, 07:15 PM
when The Heating controls are operated, no heat comes out just cold air,Do I have to replace the Heater core???
Question Asked: clutch
February 09, 2010, 04:45 PM
Yes, the master cylinder is new and the slave too. what else do you think,what's could be happening, should I replace both again?
Question Asked: clutch
February 08, 2010, 04:38 PM
I bled the system to many times , but Im thinking not all the air has come out, any other option, what else should I do
Question Asked: bleeding the system
January 21, 2010, 10:06 PM
I haven't recived my reply yet,about my clutch situation,is a brand new clutch, but it has been blead alot of times, but still not responding,the gears works, but when Im driving the RPM goes up and the acceleration speed up, with out going fast.any help,or suggestion
Question Asked: bleeding my car
January 19, 2010, 09:43 PM
I just replaced the clutch again, with a better clutch,the system has been blead, again, but whe I take a drive the gears respond ok, but in a little bit time during driving the pedal start to feels diferent,spongy, like an spring and the RPM goes up, and the engine rv and start loosing power.what should it be?
Question Asked: fuel concerns
December 12, 2009, 11:10 PM
I feel my truck burns more gas than what it should. I have to put fuel almost every two days about 12 to 15 gallons, what do you think could be the problem,
Question Asked: clutch
December 03, 2009, 08:03 PM
my master clutch cylinder, & the slave, were replaced too, both are new, why my shifter feels hard to get into the gear
Question Asked: Clutch
December 02, 2009, 10:11 PM
But my slave& clutch master, are new too,both
Question Asked: clutch
December 02, 2009, 08:22 PM
My clutch has been replaced, with a new one, but I have kind of hard time to put in gear, the shift is hard, what could it be?
Question Asked: bleeding clutch
October 09, 2009, 11:05 PM
the Reason why I want to bleed my clutch,is because I replaced one line from the sleve cylinder.. and I noticed that my clutch pedal is loose,, what do you think
No activities found
No activities found
No activities found
No activities found