SHOWBIZ

Rookie
0 points
Recent Activity

Question Asked: where are the bleeder valves to bleed coolant? I found 1 is there more than 1?
December 17, 2013, 06:38 PM
I have changed Thermostat & heater worked great 3 days. Then car overheated. I replaced thermostat again. code went out then had to replace (MAF) sensor. Then all codes & Ser. Eng. Light all cleared out. Heater will not blow hot or warm air. All is cold. I have bleed air from the one Purge valve that I found for 4 to 5 days now over & over. I have purchased a kit to flush out the whole coolant system But not sure of proper route with this car. Kit states to cut Inlet heater hose & place (T) valve in it. I cant find enough room to do this. Then it suggested to take the top hose off radiator. It looks as if I flush or put water into radiator. it also suggest to run car at idle while flushing till all is clear water. How or is the coolant going to circulate if I got hose off?
No activities found
No activities found
No activities found
No activities found