1999 Toyota Corolla Problems

RepairPal has identified the most common problems with the 1999 Toyota Corolla as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
×
Choose your vehicle
12
Known Problems

If the engine will not crank over, the most common problem is the starter. These will tend to go out at about 100,00-125,000 miles. Sometimes it is only the starter solenoid, but often the complete starter (including solenoid) needs to be replaced.

At higher mileages, (125,000-150,000) the automatic transmission may not shift correctly. This can be caused by the throttle position sensor being out of adjustment or a shift solenoid needing to be replaced. Typically the transmission does not need to be completely overhauled.

There are occasional reports of daytime running light problems.

The Check Engine Light may illuminate due to an evaporative emission (EVAP) system fault. Our technicians tell us these EVAP system faults can be difficult to diagnose but it is not uncommon to find a failed charcoal canister or a loose or worn gas cap.

Drivers of the Toyota Corolla may notice excessive oil consumption between oil changes, even to the extent of the engine oil warning light displayed on the multi-function display.

This issue is known to be caused by infrequent oil changes causing engine sludge, or worn piston rings. 

The engine should be cleaned of oil sludge, and if oil consumption remains excessive, the engine may need new piston rings, or other internal components replaced. 

To avoid this issue, change the engine oil and filter every 3,000 miles, and ensure the proper grade of oil is used. 

The Toyota Corolla 1.8L produced between 1998 and 1999 has a known issue with the valves that if left unchecked, will cause burned valves and engine performance issues. 

The engine ‘breathes’ through valves that are pushed open by the camshaft, and closed by springs. When valves are closed, they seal against a valve seat. In this vehicle, the valve seat is too soft, so after the valve contacts it thousands of times, it becomes crushed. Once it is crushed, the valve can no longer make a proper seal, and the valves erode due to extreme temperature (burnt valve).

Symptoms related to this issue:

To repair the burnt valves, the cylinder head must be removed and rebuilt, which is a costly internal engine repair, however, this issue can be prevented through inspection and adjustment of valve clearances every 40,000 miles.

The mass air flow sensor on higher mileage cars occasionally needs to be cleaned or replaced if sluggish acceleration is experienced or the Check Engine Light is illuminated with a mass air flow meter sensor fault code stored.

The rear Oxygen sensors are a critical element in fuel control (unlike other vehicles) and can cause an emissions test failure for high CO and HCs. The sensing element cracks and and reports an erroneous steady state lean condition which confuses the engine computer.

If the vehicle develops an annoying, clunking sound when driving over bumps it is usually the struts and strut bearing plates. These may need replacing at 100,000-125,000 miles or sooner. If the noise is a more of a squeak or groan, it can be usually be eliminated by spraying a light lubricant on the suspension bushings 1-2 times per year.

The bolts attaching the front door window glass to the window regulator may come loose. This can cause the window regulator to become damaged and possibly causing the window glass to break. Some 2003 & 2004 models have been recalled for the issue.

The Evaporative system may have problems with the vapor canister releasing charcoal pellets that plug the vent valve. Typically a Code P0441, P0442 and P0446 will be set. The key code is the P0446 which is a vent valve electrical failure. The proper repair is to replace the entire canister with all the valves as a unit. This is located on top of the fuel tank and is expensive. Our Technicians tell us that for awhile Toyota was covering these problems, but this may have changed. It would not hurt to call the dealer if this problem occurs to see if Toyota is still helping with these repairs.