2011 Volkswagen Tiguan Problems
RepairPal has identified the most common problems with the 2011 Volkswagen Tiguan based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.
The Volkswagen Tiguan uses the TSI direct injection engine. This engine is subject to carbon buildup in the intake system which can cause power loss, OBD codes and a check engine light, and a rough idle. In normal engines, the engine is cleaned by the gasoline flowing through the injectors and into the intake system, however, since the Tiguan uses direct injection, gasoline does not flow through common carbon buildup areas.
The solution is to remove the intake manifold and professionally clean the intake manifold, intake ports on the cylinder head, and the intake valves. This may need to be done in as few as 20,000 miles.
Popping sounds from the rear of the vehicle may be heard moments after starting the engine, or when slowing to a stop. This noise is from the leak detection pump filling the fuel tank with air, and releasing to retest the system when it finds a fault. The sequence of faults identifying this issue are as follows:
- Succession of loud pops from rear of vehicle
- Pops go away, and fuel economy decreases
- Check engine light illuminates
- OBD trouble code P2404 and/or P0441 is stored
- Engine will not start after refueling (must crank for over 30 seconds)
- Vibration when slowing to a stop
The cause is a valve which is mounted on the front of the intake manifold, commonly called the N80 valve, or EVAP system purge valve. The valve is designed to open under specific circumstances, but a worn valve will remain open at all times, preventing the pressurization of the fuel tank.
Correction of the issue is to replace the N80 valve with the latest revision.
Drivers of the Volkswagen Tiguan may experience a clunking noise associated with acceleration from a stop, or downshifting for hard acceleration. This will also be accompanied by a light impact sensation under the drivers feet. Drivers may also notice unexplained changes to their front end alignment while driving.
This issue is commonly called " VW Subframe Clunk", and is caused by the gradual stretching of the bolts that secure the subframe to the vehicle. The subframe is a large plate that secures to the bottom of the engine bay, and connects the body of the car to the engine and suspension. Over time, the bolts that secure the subframe stretch, allowing the subframe to move and hit the bottom of the car when accelerating.
There are many aftermarket kits that can be installed to correct the issue, and Volkswagen has issued a correction including better bolts, and spacers which fit between the subframe and the car.