More About Points »
DTC DESCRIPTOR This diagnostic procedure supports the following DTC: DTC P0446 Evaporative Emission (EVAP) Vent System Performance CONDITIONS FOR RUNNING THE DTC Before the PCM can report DTC P0446 failed, DTCs P0442 and P0496 must run and pass. DTCs P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0125, P0128, P0443, P0449, P0451, P0452, P0453, P0455, P0502, P1106, P1107, P1111, P1112, P1114, P1115, P1125, P1516, P2101, P2108, P2119, P2120, P2125, P2138 are not set. The ignition voltage is between 10-18 volts . The barometric pressure (BARO) is more than 75 kPa . The fuel level is between 15-85 percent . The engine coolant temperature (ECT) is between 4-30°C (39-86°F) . The intake air temperature (IAT) is between 4-30°C (39-86°F) . The start-up ECT and IAT are within 9°C (16°F) of each other. The vehicle speed sensor (VSS) is less than 129 km/h (80 mph) . DTC P0446 runs once per cold start when the above conditions are met.
Is your engine 1ZZ-FE or 2ZZ-GE
The in-line fuel filter is located underneath the vehicle between the fuel tank and fuel injection supply manifold
What type of Rotors are you installing?
Alignment is necessary, and do have camber adjustments with camber bolts.
Heater Core Replace With AC 2.8 Does not include: Evacuate and recharge system. Without AC 1.4 Note With Console, Add 0.5 Part is around $100
Your turn switch (on the steering wheel) could be damaged (contacts) grab another one from wreckers.
You could have defective coolant temp sending unit or the computer might be acting up.
This is Tricky....put a higher amp fuse and keep your eyes and nose ready see where the smoke or smell coming from this should help you BE CAREFULL not to catch fire.
What is Your Engine Size?