» » »

Problems for specific Toyota Camry years:

Car problem reports

Report A Problem

Problem with your car? See what our experts say or submit your own.

Most reported 1994 Toyota Camry problems

 

Verified for the Toyota Camry

The power steering pump and power steering hoses tend to develop leaks, particularly in the V6 models.

135 Reports
Me Too

Verified for the Toyota Camry

One or more motor mounts may wear out on cars with high mileage. This will put extra stress on the other mounts, and the faulty mount(s) should be replaced.

91 Reports
Me Too

Verified for the Toyota Camry

The valve cover gaskets have a tendency to leak oil, especially the one near the firewall.

74 Reports
Me Too

Verified for the Toyota Camry

At higher mileages, (125,000-150,000) the automatic transmission may not shift correctly. This can be caused by the throttle position sensor being out of adjustment or a shift solenoid needing to be replaced. Typically the transmission does not need to be completely overhauled.

41 Reports
Me Too

Verified for the Toyota Camry

The pickup coil inside the distributor can fail and cause a no-start condition. There have also been some failures of the radio noise suppressors inside the distributor which can short out. It is recommended to replace the whole distributor with a complete genuine Toyota distributor if any of its components fail.

31 Reports
Me Too

Verified for the Toyota Camry

The EGR System tends to get restricted or blocked with carbon after 100,000- 125,000 miles which will cause an emissions test failure for NOX. If the EGR system is equipped with an EGR temperature sensor it will trigger a Check Engine Light for improper EGR flow. The repair is to clean out the EGR passages and the EGR Temperature sensor. Our technicians tell this repair is pretty straight forward and takes about 1-1.5 hours. It is also wise to verify the EGR system components i.e. the Transducer, EGR Valve and VSV Solenoid at this time.

31 Reports
Me Too

Verified for the Toyota Camry

The rear light wiring harness can break where it attaches to the trunk hinge. As a result, the reverse lights or the shift indicator may not work and the rear bulb fault indicator may stay on constantly. The harness can be repaired and does not have to be replaced.

20 Reports
Me Too

Verified for the Toyota Camry

Driving over bumps causes loud, annoying noises in the body of the car. If the noise is a groaning or creaking, it can be improved by lubricating the rubber joints in the suspension system. If the noise is a rattling sound, the problem is likely wear and tear on the upper mounting plate for one or more of the suspension struts.

16 Reports
Me Too

Verified for the Toyota Camry

The ignition coil inside the distributor may fail. Our technicians tell us this may result in a hesitation on acceleration, especially when the vehicle is warming up on cold, rainy days. The pickup coils inside the distributor can also fail and cause a no-start condition. There have also been some failures of the radio noise suppressors inside the distributors, which can short out. Our technicians recommend replacing the whole distributor with a complete, genuine Toyota distributor if any of its components fail.

13 Reports
Me Too

Verified for the Toyota Camry

If the vehicle will not crank over, the most common problem is the starter, which tend to fail at about 100,00-125,000 miles. Sometimes it is only the starter solenoid contacts, but often the complete starter (including solenoid) needs to be replaced.

13 Reports
Me Too

Verified for the Toyota Camry
Our technicians report that by 100,000 miles, the ignition key tends to wear out and should be replaced or it may not work as well in the door locks or ignition lock cylinder.
11 Reports
Me Too

Verified for the Toyota Camry

Over the time the exhaust gas recirculation (EGR) system may become plugged with debris, the oxygen sensor may also be getting slow or 'lazy' around this time. When servicing or cleaning  the EGR system, it is a good idea to replace the oxygen sensor because it works in tandem with the EGR system.

9 Reports
Me Too

Verified for the Toyota Camry

A rough idle and even an emissions inspection failure for high HC and CO can be caused by improperly adjusted valves. Also, exhaust valves may become to tight which can lead to valve failures. Our technicians tell us that regular valve adjustment inspections are a must.

8 Reports
Me Too

Verified for the Toyota Camry

At higher mileages, an anti-lock brake system wheel speed sensor may wear out and illuminate the ABS warning light. It is recommended to replace the sensor with a factory part and be sure to clean all rust and debris from the mounting area because the mounting distance is critical. Failure to do so may result in the new sensor setting false trouble codes. Be sure to check the condition and runout of the front wheel bearings on the 2WD and 4WD vehicles and the CV joints on the 4WD vehicles since worn wheel bearings and/or CV joints can cause the ABS trigger rings to rub against the ABS sensors and damage them.

8 Reports
Me Too

Verified for the Toyota Camry

On vehicles with a manual transmission, worn shift bushings can cause the transmission to pop out of gear, especially when coasting down in 1st or 2nd gear. Replacing all the shift linkage bushings is pretty straight forward and not expensive and will commonly correct this concern.

8 Reports
Me Too
Ask a Question