2007 Mercedes-Benz SLK280 Problems

RepairPal has identified the most common problems with the 2007 Mercedes-Benz SLK280 as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
×
Choose your vehicle
8
Known Problems

The engine in the SLK280 is known by Mercedes Benz to have issues due to a poorly manufactured gear on the balance shaft (also known as the counter-rotating assembly). Since the balance shaft gear is driven by the timing chain, which keeps the engine rotating synchronously, when it fails, the timing of the engine will change causing:

- Illumination of the Check Engine Light

- Rough Running Conditions

- Stalling

- Loud Rattle or Slapping Noise

OBD Trouble Code P1200 and P1208

Correction for this issue is replacement of the balance shaft, or balance shaft gear. Replacement of the timing chain and tensioner should be done as well. The Mercedes Benz dealer may cover some or all of the repair cost on select vehicles as a result of a class action settlement.

Vehicles equipped with a 7-speed automatic transmission may develop a rough shifting condition, most commonly going up from first to second gear and going down from third to second or second to first gear. Our technicians tell us this is due to an internal component failure. Mercedes has released updated parts; the transmission will need to be removed and disassembled to complete the necessary repairs.

The camshaft adjuster solenoid (which is related to the variable valve timing system) may fail or timing chain/balance shaft components may wear, resulting in illumination of the Check Engine Light and various drivability issues. Mercedes-Benz has released a service bulletin outlining specific repair instructions depending on fault codes stored.

As a way to increase braking performance, the brake pads and rotors are make of a softer material and may be in need of replacement after approximately 20,000 miles; owners should be vigilant about getting their brakes checked.

The engine may develop a stalling and/or no start condition due to a failed crankshaft position sensor.

A vibration felt through the center floor of the vehicle can be caused by driveshaft flex discs, which crack and shred, causing excessive driveshaft movement. Not repairing these can cause damage to the driveshaft center support bearing, or, in the worst case scenario, damage to the transmission or differential.

High mileage or older vehicles commonly develop leaks from the differential seals and/or cover. Our technicians recommend a complete reseal of the differential unit whenever these leaks are repaired.

It is not uncommon to encounter premature failure of the anti-lock brake system (ABS) modulator assembly due to dirty brake fluid. Our technicians recommend flushing the brake fluid every two years in order to help prevent this problem.