Problem Reports
Problem with your car? See what our experts say or submit your own.
2003 Mercedes-Benz SLK230 Problems
Inside Grab Handles/Upholstery/Door Trim Panels May Delaminate
Inside grab handles, the upholstery on the center console cover, and door trim panels can delaminate. Most commonly replacement of the affected part is necessary.
High Usage Vehicles May Experience Ignition Lock and Tumbler Failures
Due to wear, high usage vehicles can experience ignition lock and tumbler failures. The ignition lock cylinder will generally require replacement to correct this concern.
Oil From Cam Adjuster Solenoid May Leak into Engine Wiring Harness
Engine oil can leak into the engine wiring harness from the cam adjuster solenoid. The oil can migrate through the wires and possibly damage the engine control unit. A leaking adjuster solenoid should be replaced.
Check Engine Light On Due to Failed Mass Air Flow Sensor
The mass air flow sensor can fail, resulting in poor fuel economy and Check Engine Light illumination.
Brake Light Switch Failure May Cause ESP/BAS Warning Lights
The ESP and BAS warning lights may illuminate due to a failed brake light switch. Replacement of the failed switch should correct this concern.
The Differential May Develop Leaks From the Seals or Cover
Leaks may develop from the differential cover and/or seals on high mileage or older vehicles. Our technicians recommend a complete reseal of the differential unit if these leaks are addressed.
Transmission May Leak Fluid and Damage Control Module
The electrical connector at the automatic transmission may leak fluid. Over time leaking fluid could migrate through the wiring harness and damage the transmission control module. If that happens a new harness and control module may be necessary to correct the problem.
Premature Tire Wear Due to Cracked Lower Control Arm Bushings
Irregular and premature tire wear can be caused by the lower control arm bushings cracking, resulting excessive movement at the control arm pivot point. Ball joints can also wear out prematurely, causing similar tire wear symptoms. I some cases it may be necessary to replace the lower control arm, including bushings & ball joint to correct this concern.
Squeaking/Worn Brake Pads May Require Rotor Replacement Also
Due to the size and material used on the brakes of these vehicles, the brakes may start to squeak around the 50 percent wear point. The brake rotor surfaces become uneven, causing a lip to form at the outer edge of the rotor. Because of this, the rotors are usually replaced when the pads are worn (pad life varies depending on driving style and terrain).
Engine Oil and Coolant Leaks Resulting in Fulid Intermix
Internal and External engine oil & coolant leaks can develop from the head gasket and/or timing cover gasket; these leaks should be repaired before the engine oil and coolant intermix which can result in severe engine damage.
Check Engine Light and Engine Misfire
Failed spark plug wires and/or ignition coils can cause intermittent misfires (rough running); the Check Engine Light may also illuminate. Diagnoses of the ignition system will be necessary to determine which components are at fault.
Coolant Leak/Overheating Due to Radiator Leak
A coolant leak may develop form the Radiator due to degradation of its plastic components. Replacement of the failed radiator will be necessary.
Fluid Leak From Front of Vehicle
A fluid leak from the front of the vehicle may be a result of a worn steering dampening shock. Our technicians tell us that if a leak is noted from the dampening shock it should be replaced.
ABS Modulator Failure Due to Dirty Brake Fluid
The anti-lock brake system (ABS) modulator assembly may fail due to dirty brake fluid. Our technicians recommend a complete brake system flush every two years in order to help prevent this problem.