Problem Reports
Problem with your car? See what our experts say or submit your own.
1995 Mercedes-Benz SL320 Problems
Hard/soft Tops May Develop Problems Due to Age
As vehicles age, various problems may develop with the hard and soft tops. If problems are encountered, it would be recommended to have a technician familiar with these tops perform the diagnoses.
Premature Tire Wear Due to Cracked Lower Control Arm Bushings
The lower control arm bushings can wear and crack, resulting excessive movement at the control arm pivot point, leading to irregular and premature tire wear. Worn Ball joints can also cause similar tire wear symptoms. I some cases it may be necessary to replace the lower control arm, including bushings & ball joint to correct this concern.
Rough running motor/lack of power due to failed ignition coil packs/spark plug resistors
Failed ignition coil packs or spark plug resistors can cause a rough running motor or lack of power.
Throttle Valves May Experience Electrical Failure
The electronic throttle assembly may suffer an electrical failure. It is often cheaper to send the valve to a service center for repair that to purchase a new part.
Engine Oil and Coolant Leaks Resulting in Fulid Intermix
Internal and External engine oil & coolant leaks can develop from the head gasket and/or timing cover gasket; these leaks should be repaired before the engine oil and coolant intermix which can result in severe engine damage.
ABS Modulator Failure Due to Dirty Brake Fluid
As brake fluid becomes dirty over time, it can cause a failure of the anti-lock brake system (ABS) modulator assembly. Our technicians recommend a complete brake system flush every two years to help prevent this issue.
Excess Free Play in Steering and/or Alignment Issue
One or more of the following steering linkage components may wear prematurely; tie rod ends, drag link, or idler arm. Our technicians remind us the wheel alignment should be checked and adjusted if any of these items are replaced.
Harsh Ride From Rear Due to Failed Dampening Actuator
Vehicles with automatic level control that ride harshly in the rear (no give in the suspension) may have one or both dampening actuators which have failed. It is commonly recommended the actuators be replaced in pairs.
Cracked Driveshaft Flex Discs May Cause Driveshaft Movement/Vibration
A vibration felt through the center floor of the vehicle can be caused by cracked and/or shredded driveshaft flex discs, resulting in excessive driveshaft movement. If not repaired, damage to the driveshaft center support bearing, transmission, or differential can occur.
Head Light Lenses Become Cloudy/Opaque
Due to exposure to the sun, lenses for head lights may become opaque (cloudy or hazy). This reduces the effectiveness of the lights. Our technicians tell us plastic polishes can improve the clarity of the lenses, but replacement of the lamp housings is the only way to regain the full intensity of the lights.
Transmission Oil Seals May Leak on High Mileage Vehicles
High mileage vehicles may develop a leak from one or more of the transmission oil seals.
Coolant Leak/Overheating Due to Radiator Leak
A coolant leak may develop form the Radiator due to degradation of its plastic components. Replacement of the failed radiator will be necessary.
Bad Switch/Blower Motor Resistor Assembly May Cause Inoperative Heater Blower Motor
Other than a defective motor, a bad switch or blower motor resistor assembly can cause an inoperative heater blower motor.
Coolant Hoses May Fail Unexpectedly
The cooling system hoses may fail unexpectedly. The hoses can look good on the outside, but the rubber can degrade and erode on the inside. If not carefully checked, the hoses can burst at any time.
Fluid Leak From Front of Vehicle
A fluid leak from the front of the vehicle may be a result of a worn steering dampening shock. Our technicians tell us that if a leak is noted from the dampening shock it should be replaced.