2010 Mercedes-Benz S550 Problems

RepairPal has identified the most common problems with the 2010 Mercedes-Benz S550 as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
×
Choose your vehicle
7
Known Problems

The Mercedes Benz S550 may have engine oil seeping or leaking from the back of the cylinder heads. This is commonly misdiagnosed as leaking valve covers.

On the back of the cylinder heads there are three, in total, plastic expansion plugs that plug access ports to the camshafts. These plugs are well known for seeping oil, and leaking if left unattended. The oil will run down the back of the engine and eventually make it to the ground. 

Replacement of these three plastic plugs is extremely simple, and should be done as regular maintenance. The recommended interval for replacement is every 60,000 miles.

The engine may develop a stalling and/or no start condition due to a failed crankshaft position sensor.

A vibration felt through the center floor of the vehicle can be caused by driveshaft flex discs, which crack and shred, causing excessive driveshaft movement. Not repairing these can cause damage to the driveshaft center support bearing, or, in the worst case scenario, damage to the transmission or differential.

As a way to increase braking performance, the brake pads and rotors are make of a softer material and may be in need of replacement after approximately 20,000 miles; owners should be vigilant about getting their brakes checked.

The camshaft adjuster solenoid (which is related to the variable valve timing system) may fail or timing chain/balance shaft components may wear, resulting in illumination of the Check Engine Light and various drivability issues. Mercedes-Benz has released a service bulletin outlining specific repair instructions depending on fault codes stored.

The HVAC blower motor may fail. This is commonly caused by water entry through the cabin air filter areas during heavy rain or snow. Failed blower motors should be replaced. Our technicians tell us there is no special fix for this issue at this time.

It is not uncommon to encounter premature failure of the anti-lock brake system (ABS) modulator assembly due to dirty brake fluid. Our technicians recommend flushing the brake fluid every two years in order to help prevent this problem.