Problem Reports
Problem with your car? See what our experts say or submit your own.
2007 Mercedes-Benz R350 Problems
Check Engine Light Due to Faulty Camshaft Adjuster Solenoid
The camshaft adjuster solenoid (which is related to the variable valve timing system) may fail or timing chain/balance shaft components may wear, resulting in illumination of the Check Engine Light and various drivability issues. Mercedes-Benz has released a service bulletin outlining specific repair instructions depending on fault codes stored.
Problem With Ball Joints May Cause Creaking Noise
A problem with the ball joints can cause a creaking noise. There is an updated part to remedy this problem.
Rough Shifting of Automatic Transmission
Vehicles equipped with a 7-speed automatic transmission may develop a rough shifting condition, most commonly going up from first to second gear and going down from third to second or second to first gear. Our technicians tell us this is due to an internal component failure. Mercedes has released updated parts; the transmission will need to be removed and disassembled to complete the necessary repairs.
"Crank no Start" Due to Failed Crankshaft Position Sensor
The crankshaft position sensor may fail. Symptoms of this are: The engine will crank—but not start—especially when the engine is warm. The car may start again if it is left to cool off, but it may run roughly or have poor performance. Communicating these specific symptoms to your technician can save diagnostic time.
Brake Pads & Rotors May Wear After 20,000 Miles
As a way to increase braking performance, the brake pads and rotors are make of a softer material and may be in need of replacement after approximately 20,000 miles; owners should be vigilant about getting their brakes checked.
ABS Modulator Failure Due to Dirty Brake Fluid
The anti-lock brake system (ABS) modulator assembly may fail due to dirty brake fluid. Our technicians recommend a complete brake system flush every two years in order to help prevent this problem.
Cracked Driveshaft Flex Discs May Cause Driveshaft Movement/Vibration
A vibration felt through the center floor of the vehicle can be caused by driveshaft flex discs, which crack and shred, causing excessive driveshaft movement. Not repairing these can cause damage to the driveshaft center support bearing, or, in the worst case scenario, damage to the transmission or differential.