2006 Mercedes-Benz E500 Problems

RepairPal has identified the most common problems with the 2006 Mercedes-Benz E500 as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.

Refine by vehicle
×
Choose your vehicle
24
Known Problems

The Mercedes Benz E500 may have engine oil seeping or leaking from the back of the cylinder heads. This is commonly misdiagnosed as leaking valve covers.

On the back of the cylinder heads there are three, in total, plastic expansion plugs that plug access ports to the camshafts. These plugs are well known for seeping oil, and leaking if left unattended. The oil will run down the back of the engine and eventually make it to the ground. 

Replacement of these three plastic plugs is extremely simple, and should be done as regular maintenance. The recommended interval for replacement is every 60,000 miles.

Catalytic converter failure is common and may cause a Check Engine Light to illuminate.

Rear air springs (bellows) may develop leaks, which causes the air pump to run more often to maintain ride height. Our technicians recommend that leaking air springs be replaced.

The crankshaft position sensor may fail. Symptoms of this are: The engine will crank—but not start—especially when the engine is warm. The car may start again if it is left to cool off, but it may run roughly or have poor performance. Communicating these specific symptoms to your technician can save diagnostic time.

The early versions of the central gateway module (which allows different systems to communicate with each other) have software problems. 

The cup holder in the center console may break.

The release tab for the center console can fall off unexpectedly.

Water can damage the weight sensor in the front, passenger seat, causing the SRS (airbag) light to illuminate. There is an electrical component in the seat cushion susceptible to fluid damage. Any spills should be dried up immediately in order to try and prevent damage to the sensor.

Failed spark plug wires and/or ignition coils can cause intermittent misfires (rough running); the Check Engine Light may also illuminate. Diagnoses of the ignition system will be necessary to determine which components are at fault.

The mass air flow sensor tends to fail causing poor fuel economy and Check Engine light illumination. The engine air filter should be replaced when the mass air flow sensor is replaced; a dirty filter can allow debris to damage the new sensor.

The relay which turns the airmatic suspension pump on may fail causing the pump to run continuously. This can result in failure of the pump motor or a dead battery as the pump motor will continue to run after the car is turned off. Also, Worn airmatic pump mount bushings can causes noises in the front axle while driving on bumpy roads or a buzzing noise while the pump is running.

This vehicle has sensotronic brake control (SBC). If the SBC light on the dash illuminates, have the brakes checked. If the SBC is not working, limited brake pressure is delivered to the front brakes, increasing the distance it takes to stop. The SBC hydraulic unit has a specific service life programmed into the control module; follow the manufacturer's recommended service procedure for proper maintenance of the SBC.

The anti-lock brake system (ABS) modulator assembly may fail due to dirty brake fluid. Our technicians recommend a complete brake system flush every two years in order to help prevent this problem.

An engine Oil leak may develop from the PCV vent housing on the valve cover and/or the inspection plate on the front of the engine.

A vibration felt through the center floor of the vehicle can be caused by cracked and/or shredded driveshaft flex discs, resulting in excessive driveshaft movement. If not repaired, damage to the driveshaft center support bearing, transmission, or differential can occur.