Instrument cluster displays tend to fail, especially the clock and gear indicators. Our technicians tell us the instrument cluster will require replacement to correct this issue.
1999 Mercedes-Benz E430 Problem Reports
Most Reported 1999 Mercedes-Benz E430 Problem Reports
A malfunctioning HVAC blower motor regulator can cause the blower motor to operate below the requested speed or not at all. Updated regulators are available; the blower motor and cover need to be replaced at the same time to upgrade the system.
A squeak from the steering column is often related to a rubber boot in the column or a seal in the power steering rack.
The crankshaft position sensor may fail. Symptoms of this are: The engine will crank—but not start—especially when the engine is warm. The car may start again if it is left to cool off, but it may run roughly or have poor performance.
Brake lamp housings can melt, resulting in a loss of contact for the brake light bulb holder. If this happens, the brake light will not work. Replacement of the damaged lamp housing should correct this problem.
Leaks may develop from the differential cover and/or seals on high mileage or older vehicles. Our technicians recommend a complete reseal of the differential unit if these leaks are addressed.
The ESP and BAS warning lights may illuminate due to a failed brake light switch. Replacement of the failed switch should correct this concern.
The switch for the vanity mirror light above the sun visor fail; there is an updated switch for some models. On the remaining models, due to a redesign, the mirror "cassette" will need replacement.
Irregular and premature tire wear can be caused by the lower control arm bushings cracking, resulting excessive movement at the control arm pivot point. Ball joints can also wear out prematurely, causing similar tire wear symptoms. I some cases it may be necessary to replace the lower control arm, including bushings & ball joint to correct this concern.
The bushings for the shifter lever wear out to the point where they break and fall out. This causes excessive movement (loose feel) in the shifter lever and a clanging-type noise when changing gears.
High mileage vehicles may develop a leak from one or more of the transmission oil seals.
Failed spark plug wires and/or ignition coils can cause intermittent misfires (rough running); the Check Engine Light may also illuminate. Diagnoses of the ignition system will be necessary to determine which components are at fault.
PSE system, voice control module, or Tele Aid module failure can cause a lack of audio. These same modules can also cause dead battery conditions when they fail to "time out." Many electronic control modules are active even when the engine is off. If these modules stay active, they will drain the battery, which is why they have a timer built into the modules. The timer shuts down the modules after a preset amount of time (timing out). If a module does not time out, it will stay active and drain the battery.