2002 Mercedes-Benz E320 Problem Reports

Most Reported 2002 Mercedes-Benz E320 Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

Instrument cluster displays tend to fail, especially the clock and gear indicators. Our technicians tell us the instrument cluster will require replacement to correct this issue.

The crankshaft position sensor may fail. Symptoms of this are: The engine will crank—but not start—especially when the engine is warm. The car may start again if it is left to cool off, but it may run roughly or have poor performance.

Due to wear, high usage vehicles can experience ignition lock and tumbler failures. The ignition lock cylinder will generally require replacement to correct this concern.

A squeak from the steering column is often related to a rubber boot in the column or a seal in the power steering rack.

The ESP and BAS warning lights may illuminate due to a failed brake light switch. Replacement of the failed switch should correct this concern.

Brake lamp housings can melt, resulting in a loss of contact for the brake light bulb holder. If this happens, the brake light will not work. Replacement of the damaged lamp housing should correct this problem.

A malfunctioning HVAC blower motor regulator can cause the blower motor to operate below the requested speed or not at all. Updated regulators are available; the blower motor and cover need to be replaced at the same time to upgrade the system.

High mileage vehicles may develop a leak from one or more of the transmission oil seals.

Failed spark plug wires and/or ignition coils can cause intermittent misfires (rough running); the Check Engine Light may also illuminate. Diagnoses of the ignition system will be necessary to determine which components are at fault.

An engine oil leak may develop from the oil level sensor. Replacement of the leaking sensor will commonly correct this concern.

The third (high) brake light housing may melt, resulting in a loss of electrical contact for the light, which stops working. A complete housing (contacts and lens) is needed to repair the problem. On certain vehicles, if this happens, the anti-lock brake system will not function. The brakes will work in normal mode, but not provide the ABS control.

The evaporator temperature sensor can fail, causing the AC compressor not to cycle. If the AC compressor does not turn on, the AC system will not blow cold air. If the compressor is stuck on, the air will be very cold at first, before warming up.

The bushings for the shifter lever wear out to the point where they break and fall out. This causes excessive movement (loose feel) in the shifter lever and a clanging-type noise when changing gears.

The brakes may begin to squeak at about the 50 percent wear point. This is due to the size and material used for the brake pads and rotors.  The brake rotor surfaces become uneven, causing a lip to form at the outer edge. This will generally require replacement of the rotors when the pads are worn (pad life varies depending on driving style and terrain).

Cup holders break easily, especially if sticky liquids are spilled into the cup holder mechanism.