2002 Mercedes-Benz CL600 Problems
RepairPal has identified the most common problems with the 2002 Mercedes-Benz CL600 as reported by actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.Refine by vehicle
A door control module/actuator may fail. Our technicians recommend finding an expert to repair them. Taking the door trim panels off requires expert knowledge because they can break and the pieces are very expensive.
The engine oil coolers may leak; Our technicians tell us removal of the cylinder heads is required to correct this leak.
The active body control system can leak fluid from numerous areas, including the tandem pump, hydraulic lines, struts, and/or seals. If it is not repaired, the vehicle ride height could drop too low and cause damage to the undercarriage.
Leaks may develop from the differential cover and/or seals on high mileage or older vehicles. Our technicians recommend a complete reseal of the differential unit if these leaks are addressed.
Due to the size and material used on the brakes of these vehicles, the brakes may start to squeak around the 50 percent wear point. The brake rotor surfaces become uneven, causing a lip to form at the outer edge of the rotor. Because of this, the rotors are usually replaced when the pads are worn (pad life varies depending on driving style and terrain).
Engine misfires (rough running) and lack of power are commonly caused by ignition coil pack or ignition module faults. Proper diagnoses should isolate the cause and prevent unnecessary replacement of good parts.
A faulty mass air flow (MAF) sensor can cause erratic/rough engine operation and fuel economy issues. Since this sensor measures the actual amount of air entering the motor, when it fails, the engine control module (ECM) takes the wrong information and delivers incorrect volumes of fuel to the cylinders.
A vibration felt through the center floor of the vehicle can be caused by cracked and/or shredded driveshaft flex discs, resulting in excessive driveshaft movement. If not repaired, damage to the driveshaft center support bearing, transmission, or differential can occur.
The center console armrest can break. Replacement is commonly the recommended repair.
Analog Tele Aid units are no longer supported and must be updated to digital, preferably at a dealership or a well-equipped independent shop. The update and all related factors should be completed at the same time.