The active body control system can leak fluid from numerous areas, including the tandem pump, hydraulic lines, struts, and/or seals. If it is not repaired, the vehicle ride height could drop too low and cause damage to the undercarriage.
Car problem reports
Problem with your car? See what our experts say or submit your own.
Most reported 2004 Mercedes-Benz CL500 problems
A vibration felt through the center floor of the vehicle can be caused by cracked and/or shredded driveshaft flex discs, resulting in excessive driveshaft movement. If not repaired, damage to the driveshaft center support bearing, transmission, or differential can occur.
Due to the size and material used on the brakes of these vehicles, the brakes may start to squeak around the 50 percent wear point. The brake rotor surfaces become uneven, causing a lip to form at the outer edge of the rotor. Because of this, the rotors are usually replaced when the pads are worn (pad life varies depending on driving style and terrain).
The engine may develop a stalling and/or no start condition due to a failed crankshaft position sensor.
A door control module/actuator may fail. Our technicians recommend finding an expert to repair them. Taking the door trim panels off requires expert knowledge because they can break and the pieces are very expensive.
The side window glass can delaminate. If this were to occur, replacement of the affected window would be necessary.
The center console armrest can break. Replacement is commonly the recommended repair.
Leaks may develop from the differential cover and/or seals on high mileage or older vehicles. Our technicians recommend a complete reseal of the differential unit if these leaks are addressed.
CD changers, command units, voice control units, PSE units, and Tele Aid units are prone to failure, especially in early models.
The door for the vanity mirror (or the frame for the door) can break; due to a redesign, the mirror "cassette" will need replacement.
The electrical connector at the automatic transmission may leak fluid. Over time leaking fluid could migrate through the wiring harness and damage the transmission control module. If that happens a new harness and control module may be necessary to correct the problem.
An engine Oil leak may develop from the PCV vent housing on the valve cover and/or the inspection plate on the front of the engine.