2009 Mercedes-Benz C350 Problem Reports

Most Reported 2009 Mercedes-Benz C350 Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

A repetitive clicking noise from behind the center area of the dash panel is usually caused by a broken stepper motor actuating arm. The actuating arm controls the direction of air flow in the climate control system. Disassembly of the center console will be required to access and change the broken arm with the updated, reinforced part.

The anti-lock brake system (ABS) modulator assembly may fail due to dirty brake fluid. Our technicians recommend a complete brake system flush every two years in order to help prevent this problem.

The mass air flow sensor tends to fail causing poor fuel economy and Check Engine light illumination. The engine air filter should be replaced when the mass air flow sensor is replaced; a dirty filter can allow debris to damage the new sensor.

A vibration felt through the center floor of the vehicle can be caused by driveshaft flex discs, which crack and shred, causing excessive driveshaft movement. Not repairing these can cause damage to the driveshaft center support bearing, or, in the worst case scenario, damage to the transmission or differential.

The heater case for the center vents can crack near the stop sensors. If the stops break, the control motor will not know when to stop and will run continuously.