2007 Mercedes-Benz C230 Problems
RepairPal has identified the most common problems with the 2007 Mercedes-Benz C230 based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.
The camshaft adjuster solenoid (which is related to the variable valve timing system) may fail or timing chain/balance shaft components may wear, resulting in illumination of the Check Engine Light and various drivability issues. Mercedes-Benz has released a service bulletin outlining specific repair instructions depending on fault codes stored.
The engine in the C230 is known by Mercedes Benz to have issues due to a poorly manufactured gear on the balance shaft (also known as the counter-rotating assembly). Since the balance shaft gear is driven by the timing chain, which keeps the engine rotating synchronously, when it fails, the timing of the engine will change causing:
-Illumination of the Check Engine Light
-Rough Running Conditions
-Loud Rattle or Slapping Noise
-OBD Trouble Code P1200 and P1208
Correction for this issue is replacement of the balance shaft, or balance shaft gear. Replacement of the timing chain and tensioner should be done as well. The Mercedes Benz dealer may cover some or all of the repair cost on select vehicles as a result of a class action settlement.
A repetitive clicking noise from behind the center area of the dash panel is usually caused by a broken stepper motor actuating arm. The actuating arm controls the direction of air flow in the climate control system. Disassembly of the center console will be required to access and change the broken arm with the updated, reinforced part.
The CD changer may suffer from an internal mechanical problem. Replacement of the faulty unit is generally required to correct this issue.
Inside grab handles, the upholstery on the center console cover, and door trim panels can delaminate. Most commonly replacement of the affected part is necessary.
The electrical connector at the automatic transmission may leak fluid. Over time leaking fluid could migrate through the wiring harness and damage the transmission control module. If that happens a new harness and control module may be necessary to correct the problem.
The ESP and BAS warning lights may illuminate due to a failed brake light switch. Replacement of the failed switch should correct this concern.
The crankshaft position sensor may fail. Symptoms of this are: The engine will crank—but not start—especially when the engine is warm. The car may start again if it is left to cool off, but it may run roughly or have poor performance. Communicating these specific symptoms to your technician can save diagnostic time.
A dead battery can be caused by a faulty seat control module that does not properly shut down. Spilling liquids on the front seats can cause these modules to fail.
The SRS (airbag) light can come on if liquids are spilled into the seat belt buckles, or if the liquid pools underneath the seat and gets into the electrical connector for the seat belt pretensioner. Damaged components will require replacement to restore proper airbag operation.
The heating, ventilation and AC (HVAC) heater box is susceptible to mildew buildup. This can result in a musty odor from the HVAC system, most noticeable when the system is first turned on.
The sway bar end link joints may wear and cause a knocking noise over bumps. Loose or warn links should be replaced to correct this type of noise.
A vibration felt through the center floor of the vehicle can be caused by cracked and/or shredded driveshaft flex discs, resulting in excessive driveshaft movement. If not repaired, damage to the driveshaft center support bearing, transmission, or differential can occur.