Problems for specific Jeep Cherokee years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Most reported 1998 Jeep Cherokee problems
A ticking type noise may be noted from the engine area due to an exhaust manifold that has cracked where the pipes are welded; cracked manifolds should be replaced.
Leaks at the front and/or rear differential pinion seal and from the transfer case are common. Leakage from the transfer case normally occurs at the case-mating surfaces and require removal of the transfer case to reseal.
The throttle body may accumulate an oily, black residue in the bore and on the throttle plate causing hard starting or possibly stalling when coming to a stop. The throttle body should be cleaned during regular maintenance but do not spray cleaners directly on or at the throttle position sensor (TPS) as this can damage the sensor.
Some models are susceptible to rear main oil seal failures in dirty or dusty conditions. As dirt and dust collect on the oil seal, the abrasion wears through the sealing surface. A rubber plug, installed above the starter, is being used in production that prevents the dust entry near the seal and extends the life of the seal. The plug is available from MOPAR and should be installed any time a rear main seal service is performed.
Due to warped front brake rotors or variations in the thickness of the rotors, brake pulsations may develop. The best method to reduce pulsations is to use an "On the Car" brake lathe (as long as the rotors are suitable for turning). "On the Car" equipment can correct variations (or "runout") in the rotor surfaces because it also corrects variations in other components (e.g. the hub).
Jeep issued an emissions recall in late 2006 to update the powertrain control module (PCM) software on certain 1996 - 1998 vehicles. As part of the recall, the catalytic converter will also be inspected for damage and replaced as necessary. To see if your vehicle is included in the recall you can visit the Jeep website (owners' section) that allows owners to input their VIN number and check the recalls on their vehicle.
A loud buzzing or whining when the transmission is in reverse may be caused by a regulator valve in the transmission valve body. A revised valve was released that does not resonate. Careful diagnosis should be performed because other causes can create the noise.
A minor brake pedal pulsation may be felt at highway speeds and can be caused by rough surfaces on the brake rotor. Low quality brake pads may deposit material onto the rotor surfaces causing variation on the brake rotor surfaces. The front brake pads may need replacement and the brake rotors should be machined or replaced, if necessary.