Most reported 1995 Jeep Cherokee problems

Leaks at the front and/or rear differential pinion seal and from the transfer case are common. Leakage from the transfer case normally occurs at the case-mating surfaces and require removal of the transfer case to reseal.

The throttle body may accumulate an oily, black residue in the bore and on the throttle plate causing hard starting or possibly stalling when coming to a stop. The throttle body should be cleaned during regular maintenance but do not spray cleaners directly on or at the throttle position sensor (TPS) as this can damage the sensor.

Floor pan rust and corrosion typically happens where salt or mud is allowed to accumulate on the vehicle. Holes drilled in the floor can contribute to rust if the bare metal is not painted or protected with corrosion resistant coatings. Floor pan kits are available from Jeep and the aftermarket to repair rusted areas.

Some models are susceptible to rear main oil seal failures in dirty or dusty conditions. As dirt and dust collect on the oil seal, the abrasion wears through the sealing surface. A rubber plug, installed above the starter, is being used in production that prevents the dust entry near the seal and extends the life of the seal. The plug is available from MOPAR and should be installed any time a rear main seal service is performed.

The outer exhaust manifold studs can break and cause exhaust leaks, commonly noted as a ticking type noise. The outer studs, clamps, and nuts will need to be replaced and are now being tightened to a reduced torque value (20 Nm/180 in lbs).

Internal leaks in the speed sensor or speed sensor gear adapter (speedometer adapter) are common. A revised speed sensor (white in color, old versions are black), used in production since November of 1993, solves the problem. If leaks develop between the sensor and the adapter or between the adapter and the transmission housing (transfer case if 4WD), a revised speedometer adapter is available.