2001 Isuzu Rodeo Problem Reports

Most Reported 2001 Isuzu Rodeo Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

The fuel level sensor may fail resulting in erratic fuel gauge operation and illumination of the Check Engine Light. Replacement of the fuel sender assembly is recommended to correct this concern. A powertrain control module (PCM) software update may be necessary for the updated fuel level sensor to read correctly.

Chattering when cornering can occur when the limited slip differential fluid breaks down. Replacing the fluid will repair this issue.

On the V-6 engine, oil in the spark plug tubes can cause a misfire. Resealing the tubes as part of replacement of the valve cover gasket and replacing the spark plug wires will commonly repair this issue. On newer models the misfire can result in illumination of the Check Engine Light.

The automatic transmission accumulator cover can leak due to a failed o-ring. Replacing the o-ring and cover will commonly correct this issue.

Certain models may have a vibration issue at highway speeds that could be due to uneven tire pressures, tire rim out of specs, wheels out of balance, AC compressor bracket bolts not torqued correctly, misalignment of the steering shaft coupler, improper ride height, or wheel alignment out of adjustment. A qualified technician is needed to sort out these problems and correct them.

Rear Wiper Motor works, but on of multiple relays malfunction. Creating wiper to work intermittingly.

Rear axle seal leaks can be cause by a plugged rear differential vent. Replacing the leaking seal and clearing out the vent will fix this problem.

Certain models may have a vibration issue at highway speeds that could be due to uneven tire pressures, tire rim out of specs, wheels out of balance, AC compressor bracket bolts not torqued correctly, misalignment of the steering shaft coupler, improper ride height, or wheel alignment out of adjustment. A qualified technician is needed to sort out these problems and correct them.

On some models the powertrain control module (PCM) software delays idle speed changes during cold starts causing stalling problems. A software update is available to repair this issue.

On certain models contamination of the grease on the gas pedal potentiometer causes the Check Engine light (MIL) to come on and may cause a rough idle. The potentiometer will need to be replaced and adjusted to fix this problem.