2008 Honda S2000 Problems
RepairPal has identified the most common problems with the 2008 Honda S2000 based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.
The 2000-2009 Honda S2000 engine oil pressure sensor is known to leak from normal operation.
More information about the oil pressure sensor here.
To correct the leak, the sensor must be inspected, properly sealed and installed, or replaced with new.
Smelling burning engine oil is common on the 2000-2009 Honda S2000, and is associated with oil leaking from the valve cover. It is most common to smell the oil burning at a stop light, or just after you shut off your engine.
Engine oil leaks from the valve cover, drains down, and settles on the exhaust manifold, which burns the oil upon contact due to high exhaust gas temperatures. This creates an odor that comes through the vents, and can be smelled around the front of the vehicle.
Valve cover gasket replacement will correct both the leak and the smell of burned oil at the same time. If the ignition coil or spark plug wire was soaked in oil, it will need to be cleaned or replaced to stop or prevent misfires.
This seal wraps around the camshaft to prevent engine oil from leaking where the camshaft exits the cylinder head.
There are known convertible top issues.
On certain models the PCM misinterprets data from the coolant sensor and causes the Check Engine light (MIL) to illuminate. A software update from Honda will repair this problem.
A problem can occur with a vibrating expansion valve in the AC system and cause a whistling noise from the passengers vent. Replacing the expansion valve with an updated valve from Honda will repair this problem.
The S2000 is set up with aggressive alignment settings and soft tire compounds to enhance handling. These alignment settings and soft tire compounds result in tires wearing out earlier than anticipated. This is a compromise made to have a car with exceptional handling characteristics.